Installation Instructions - Mabe

More documents

Recommendations

Info

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions Replacing the light bulbs. Setting the controls to OFF does not remove power to the light circuit. 56 COLD OR Pocket COLDEST Tabs Refrigerator Compartment—Upper Light Unplug the refrigerator. The bulbs are located at the top of the compartment, inside the light shield. On some models, a screw at the front of the light shield will have to be removed. On other models, the screw is located in the pocket located at the back of the light shield. To remove the light shield, on some models, press in on the tabs on the sides of the shield and slide forward and out. On other models, just slide forward and out. Refrigerator Compartment—Lower Light This light is located above the top drawer. Unplug the refrigerator. Remove the convertible meat drawer control knob by pulling straight out. Lift the light shield up and pull it out. Freezer Compartment Unplug the refrigerator. Remove the shelf just above the light shield. (The shelf will be easier to remove if it is emptied first.) On some models, a screw at the top of the light shield will need to be removed. To remove the light shield, press in on the sides, and lift up and out. Dispenser (on some models) Unplug the refrigerator. The bulb is located on the dispenser under the control panel. Remove the light bulb by turning it counterclockwise. After replacing the bulb with an appliance bulb of the same or lower wattage, replace the light shield and screws (on some models). When replacing the light shield, make sure that the tabs at the back of the shield fit into the slots at the back of the light shield housing. Plug the refrigerator back in. After replacing the bulb with an appliance bulb of the same or lower wattage, replace the shield and the knob. Plug the refrigerator back in. Replace the bulb with an appliance bulb of the same or lower wattage, and reinstall the light shield. When reinstalling the light shield, make sure the top tabs snap securely into place. Replace the screw (on some models). Reinstall the shelf and plug the refrigerator back in. Replace the bulb with a bulb of the same size and wattage. Plug the refrigerator back in.
Trim kits and decorator panels. For CustomStyle models Read these instructions completely and carefully. Before You Begin Some models are equipped with trim kits that allow you to install door panels. You can order pre-cut black, white, bisque or stainless steel decorator panels from GE Parts and Accessories, 800.626.2002, or you can add wood panels to match your kitchen cabinets. Panels less than 1/4" (6 mm) thick When installing wood panels less than 1/4" (6 mm) thick, you need to create a filler panel, such as 1/8" (3 mm) cardboard, that will fit between the face of the door and the wood panel. If you are installing the pre-cut decorator panels, pre-cut filler panels are included in the kit. The combined thickness of the decorator or wood panel and the filler panel should be 1/4" (6 mm). Panels 1/4"(6 mm) thick or less 1/4"(6 mm) Max. 3/4" (19 mm) or Raised Panel A raised panel design screwed or glued to a 1/4" (6 mm) thick backing, or a 3/4" (19 mm) routed board can be used. The raised portion of the panel must be fabricated to permit clearances of at least 2" (5.1 cm) from the handle side for fingertip clearance. Panels thicker than 1/4" (6 mm), up to 3/4" (19 mm) maximum, will require that the outer 5/16" (8 mm) of panel perimeter be no thicker than 1/4" (6 mm). Weight limitations for custom panels: Fresh Food 38 lbs. (17 kg) max. Freezer Door 28 lbs. (13 kg) max. Panels thicker than 1/4"(6 mm) 5/16"(8 mm) 1/4"(6 mm) Max. 3/4"(19 mm) 2"(5.1 cm) Clearance Handle Side Appearance Panel 1/4"(6 mm) Thick Backing 3/4" (19 mm) Refrigerator Door 57 Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Consumer Support
Page 1 and 2:
No de parte 200D4036P022 rev1 instr
Page 3 and 4:
INFORMACIONES IMPORTANTES DE SEGURI
Page 5 and 6:
Los controles del refrigerador. Los
Page 7 and 8: Acerca de CustomCool . ExpressThaw
Page 9 and 10: El filtro de agua. (en algunos mode
Page 11 and 12: No todos los modelos tienen todas l
Page 13 and 14: Gavetas y cajones. No todos los mod
Page 15 and 16: El dispensador de agua y de hielo.
Page 17 and 18: Atrás del refrigerador Se deberá
Page 19 and 20: Molduras y paneles decorativos. Par
Page 21 and 22: Cómo insertar los paneles de la pu
Page 23 and 24: Instrucciones para la instalación
Page 33 and 34: CÓMO INSTALAR LA TUBERÍA DEL AGUA
Page 35 and 36: Antes de solicitar un servicio… S
Page 37 and 38: Antes de solicitar un servicio… P
Page 39 and 40: Garantía del Refrigerador. (Para c
Page 41 and 42: Notas. Importado por MABE COLOMBIA
Page 43 and 44: DANGER! RISK OF CHILD ENTRAPMENT PR
Page 45 and 46: About the temperature controls. Per
Page 47 and 48: About CustomCool . ExpressThaw Ex
Page 49 and 50: About the water filter. (on some mo
Page 51 and 52: Press tab and pull shelf forward to
Page 53 and 54: About the crispers and pans. Not al
Page 55 and 56: About the ice and water dispenser.
Page 57: Behind the Refrigerator Be careful
Page 61 and 62: Inserting the door panels. Read the
Page 63 and 64: Installation Refrigerator Instructi
Page 65 and 66: 4 DISCONNECT THE POWER COUPLING (on
Page 67 and 68: 8 D E REMOVE THE REFRIGERATOR DOOR
Page 69 and 70: 1 A B CONNECTING THE REFRIGERATOR T
Page 71 and 72: 7 8 REPLACE THE BASE GRILLE Replace
Page 73 and 74: WHAT YOU WILL NEED (CONT.) NOTE: Th
Page 75 and 76: Normal operating sounds. Newer refr
Page 77 and 78: Problem Possible Causes What To Do
Page 79 and 80: Manufactured for: General Electric
Page 81 and 82: 4 Tel. sin costo: 01800 90 29 900 I
show all

Installation Instructions - Mabe

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?