3 Other operating modes of the G-18.mft - NRI

More documents

Recommendations

Info

STARTING UP G-18.mft with vending machine control system Set exact price or overpay mode 1 De-energize the coin validator and remove from the vending machine. 2 Set the DIL switch 7 of the upper switching block S1 on the rear of the device upward to ON for "exact price" or downward (to OFF) for "overpay". "Exact price" activated "Overpay" activated 3 Hang the coin validator back in the machine again and supply with voltage. 32 National Rejectors, Inc. GmbH, Buxtehude
G-18.mft with vending machine control system STARTING UP Connecting the device environment of the PC programming station (WinEMP) If you want the G-18.mft to be set on the PC using the diagnostics and configuration software WinEMP, the following device environment is connected to the PCB direct plug 5 of the coin validator (see Fig. 2a and section "Accessories" in Chap. 10 "Technical data"): • Tester for voltage supply • WinEMP card reader incl. chip card National Rejectors, Inc. GmbH, Buxtehude Fig. 3: Device environment for WinEMP For details on how to connect the device environment to your PC and how to operate the software, please refer to the separate documentation for the WinEMP software (refer also to Chap. 9 "Which functions can be set using WinEMP/PalmEMP?"). Prior to making the connection to the programming station, the DIL switch S3.9 on the rear of the coin validator must be set upward to ON first, since otherwise it will not be possible to set up a connection to the PC. The WinEMP functions that are relevant for the vending machine control system of the G-18.mft are currently being revised. Connecting the Palm handheld (PalmEMP) "PalmEMP" is an NRI program that can be installed as an additional application on a Palm handheld. Simply use the appropriate dongle to connect the Palm handheld to the PCB direct plug 5 of the coin validator (see Fig. 2a and section "Accessories" in Chap. 10 "Technical data"). The coin validator remains installed in the vending machine. The PalmEMP functions that are relevant for the vending machine control system of the G-18.mft are currently being revised. 33
Page 1: Technical Documentation 01.06 GS/Bu
Page 4 and 5: TABLE OF CONTENTS G-18.mft with ven
Page 7 and 8: G-18.mft with vending machine contr
Page 31: G-18.mft with vending machine contr

3 Other operating modes of the G-18.mft - NRI

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?