Kuhnke Electronics Instruction Manual

Modes of Operation
3.8.3 Modes Overview
Switch Setting
0 "run" ■
PLC ready
yes no
1 stop ■
2 export 1 ■
3 import 1 ■
4 boot com1 ■
5 -- ■ No function
6 boot mc ■ No function
7 export 2 ■
8 import 2 ■
9 clear ■
Explanation
Normal op. mode:
This is the only setting that enables the
PLC functions.
Safety mode:
All PLC functions stopped, all outputs off,
no interface communication, no access
via the programming device
Save user program 1 and store on
memory card
Load user program 1 from the memory
card into the controller (flash memory)
Load monitor program via com into the
controller (flash memory)
Save user program 2 and store on
memory card
Load user program 2 from the memory
card into the controller (flash memory)
Delete user program and remanent data.
Code: 9, Off/On,1-5-9
(to enter � 3.8.3.6)
48 E 700 GB