Kuhnke Electronics Instruction Manual

Hardware
3.4.4 Analogue Outputs
Ventura Remote PLC has 2 analogue outputs labelled
ao0, and ao1. They are set by the configuration. Their
resolution can be set to either 8 bit (10V/256, i.e. approx.
39mV) or 10 bit (10V/1024, i.e. approx. 96mV). They
attach to the screw-type locking terminal. Immediately
next to the analogue input, there is a terminal for the
analogue reference potential. All analogue reference
potential terminals are interconnected.
ao
1
0
Signal pin wiring
The screw-type locking terminals
are safe for use with conductors of
a diameter between 0.25 mm 2 and
1.5 mm 2 .
To avoid noise on the operative
signal, you are advised to use
shielded cables. Attach the shield
to the earth conductor terminals on
the left side wall.
40 E 700 GB