Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke

KUHNKE Automation Fuxx Control ARS 2320 / ARS 2340
The outer cable shield of the motor cable has to be connected flat to the mounting plate
of the controller housing using shield terminal SK14.
Table 33: Motor temperature monitoring system and holding brake [X6A]
Pin no. Name Value Specification
1 MT+ +5 V / 5 mA
2 MT- GND
Motor temperature sensor: Normally closed
contact, normally open contact, PTC
3 PE - Shield of motor temperature monitoring system
4 PE - Shield of motor holding brake
5 BR+ 24 V brake, 2A max.
6 BR- 0 V brake
Holding brake (motor), signal level depending on
switching state, high-side / low-side switch
8.6.8 Type and configuration of cable [X6] and [X6A] at the ARS 2320
The cable names given refer to cables made by Lapp. They have proven to be reliable and are
successfully used in many applications. However, it is also possible to use comparable cables from
other manufacturers, e.g. Lütze or Helukabel.
� LAPP KABEL ÖLFLEX-SERVO 700 CY; 4 G 4 + (2 x 0.75 + 2 x 1.0) StD-CY; ∅ 16.6 mm,
with tinned CU shielding
For highly flexible applications:
� LAPP KABEL ÖLFLEX-SERVO-FD 755 CP; 4 G 4 + (2 x 0.75 StD) + (2 x 1.0 StD) CP;
∅ 16.9 mm,
with tinned CU shielding
for highly flexible use in drag chains
8.6.9 Type and configuration of cable [X6] and [X6A] at the ARS 2340
The cable names given refer to cables made by Lapp. They have proven to be reliable and are
successfully used in many applications. However, it is also possible to use comparable cables from
other manufacturers, e.g. Lütze or Helukabel.
� LAPP KABEL ÖLFLEX-SERVO 700 CY; 4 G 6 + (2 x 0.75 + 2 x 1.0) StD-CY; ∅ 17.7 mm,
with tinned CU shielding
E 732 GB 87
14.12.2006