Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke

KUHNKE Automation Fuxx Control ARS 2320 / ARS 2340
Figure 37: Position of the pin-and-socket connectors [X21] and [X22] at the front plate
11.3.4 Mating connector
� Connector [X21] for 8 digital inputs: PHOENIX MicroCombicon FK-MC 0.5/9-ST-2.5
� Connector [X22] for 8 digital outputs: PHOENIX MicroCombicon FK-MC 0.5/10-ST-2.5
11.3.5 Connection notes
The MicroCombicon mating connectors made by PHOENIX regarding [X21] (FK-MC 0.5/9-ST-2.5)
and [X22] (FK-MC 0.5/10-ST-2.5) are supplied together with the EA88 interface technology module.
The cables are connected in the form of crimp connections. To do so, strip the cable at a length of
about 8 mm. Then insert it into the desired opening by pressing down the orange crimp lock using a
suitable screwdriver, the tip of a ball-pen or something similar. Release the lock to fix the cable in
place. The maximum admissible wire cross-section (wire gauge) is 0.5 mm 2 or AWG20.
If the EA88 interface is also used to control digital outputs, an additional external 24V supply voltage
has to be connected to [X22], pin 10.
As the lines GND24V and +24Vext. have to transfer the entire current of all outputs connected, their
cross-section has to be sized accordingly (recommended: AWG 20).
E 732 GB 145
14.12.2006