Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke

Fuxx Control ARS 2320 / ARS 2340 KUHNKE Automation
Error message
Main index Subindex
14
15
16
Error message explanation Measures
0 Insufficient supply for
identification
1 Current controller identification:
Insufficient measuring cycle
The available intermediate circuit voltage is too
low for the measurement.
The automatic parameter identification process
delivers a time constant beyond the
parameterization value range. The parameters
must be optimized manually.
2 Output stage could not be enabled The power stage has not been enabled.
Check the connection of DIN4.
3 Output stage has been switched off
prematurely
4 Identification does not support the
encoder type set
The power stage has been disabled while the
identification process was running.
The identification cannot be performed with the
present angle encoder settings.
Check the configuration of the angle encoder.
If necessary, contact the technical support
team.
5 Reset pulse could not be found The index pulse could not be found after the
maximum number of electrical rotations.
Check the index pulse signal.
6 Hall signals invalid The pulse sequence or the segmentation of the
Hall signals is unsuitable.
Check the connection. If necessary, contact the
technical support team.
7 Identification impossible Ensure a sufficient intermediate circuit voltage.
Rotor blocked?
8 Invalid number of pairs of poles The number of pairs of poles calculated is
beyond the parameterization range. Check the
motor data sheet. If necessary, contact the
technical support team.
0 Division by 0
1 Range exceeded
0 Error during program execution
1 Illegal interrupt
2 Initialisation error
3 Unexpected state
Please contact the technical support team.
Please contact the technical support team.
130 E 732 GB
14.12.2006