Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke

Fuxx Control ARS 2320 / ARS 2340 KUHNKE Automation
Error message
Main index Subindex
08
09
Error message explanation Measures
0 Resolver angle encoder error
2 Incremental encoder Z0 trace
signals error
3 Incremental encoder Z1 trace
signals error
4 Digital incremental encoder trace
signals error
5 Incremental encoder Hall generator
signals error
7 Incorrect signal amplitude of
incremental tracks
8 Internal angle encoder error
9 Angle encoder at X2B not
supported
0 Outdated angle encoder parameter
set (type ARS)
1 Angle encoder parameter set
cannot be decoded
2 Unknown version of angle encoder
parameter set
3 Defective data structure of angle
encoder parameter set
7 Write-protected angle encoder
EEPROM
9 Angle encoder EEPROM not
sufficient
Angle encoder connected?
Angle encoder cable defective?
Angle encoder defective?
Check the configuration of the angle encoder
interface.
The encoder signals are disturbed: Check the
installation for compliance with EMC
recommendations.
Contact the technical support team.
The data in the angle encoder will be converted
as far as possible. To avoid this message save
the data to the EEPROM of the angle encoder
(reformatting)
Angle encoder defective?
Check the configuration of the angle encoder
interface.
The encoder signals are disturbed: Check the
installation for compliance with EMC
recommendations.
Conversion impossible. Save the data again in
the angle encoder.
Redetermine the data if necessary and save
them again in the angle encoder.
Please contact the technical support team.
Please contact the technical support team.
10 0 Overspeed (spinning protection) Check the parameterization of the limit value.
Incorrect offset angle?
128 E 732 GB
14.12.2006