Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke

Fuxx Control ARS 2320 / ARS 2340 KUHNKE Automation
Error messages
Mainindex
26
Subindex
Meaning of error message Measures
2 HW revision not supported the servo positioning controller to the sales representative.
3 Device function restricted Contact the Technical Support and - if necessary - send
the servo positioning controller to the sales representative.
0 No user parameter set Load the default parameter set.
If the error continues, contact the Technical Support.
1 Checksum error
2 Flash:
Error during write-operation
3 Flash:
Error during erase-operation
4 Flash: Error in internal flash
5 No calibration data
Please contact the Technical Support.
The error cannot be eliminated by the user.
Please contact the technical support team.
6 Missing user position data sets Simply perform save & reset.
Load the default parameter set.
If the error continues to occur, contact the Technical
Support.
7 Faulty data tables (CAM) Load default parameter set, reload the parameter set if
necessary.
If the error continues, contact the Technical Support.
27 0 Following error warning level Check the parameterisation of the following error.
Motor blocked?
28
0 Hours-run meter missing
1 Hours-run meter: write error
2 Hours-run meter correced
3 Hours-run meter converted
Please contact the Technical Support.
Acknowledge the error. If the error continues to occur,
contact the Technical Support.
30 0 Internal calculation error Please contact the Technical Support.
31
0 I²t motor Motor blocked?
1 I²t servo controller Check the power rating of the drive package.
2 I²t-PFC Check the power rating of the drive package.
Select operation without PFC?
3 I²t-Break resistor Braking resistor overloaded. Use external braking resistor?
32 0 Loading period DC-bus exceeded Please contact the Technical Support.
124 E 732 GB
14.12.2006