Ventura IPC Instruction Manual pdf - Kuhnke

Software KUHNKE Automation
8 Troubleshooting
8.1 General Problems
Problem Cause Actions
Unit won't work. Power not supplied to unit. Check power supply.
Incorrect PC time and/or date. 1. At boot-up, press to run the
BIOS Setup.
2. Set the correct time/date in the Setup
menu.
Monitor won't work after booting
the Ventura IPC.
On-screen display won't work or
not all the time, e.g. no picture
or picture very dark.
Cable not connected to monitor.
BIOS failed to automatically find
monitor data.
Fluorescent lamp in monitor
defective.
USB device won't work. Operating system has no suitable
driver for the USB device.
Operating system does not
support the USB interfaces.
'System Status' dialog shows a
temperature of more than 80°C.
Excessive temperature inside
the Ventura IPC.
Attach cable properly.
Measure the voltage supplied, check pin
wiring.
Set the TFT option of BIOS Setup to the
correct resolution ( at boot-up).
Run Control Panel utility or KUHNKE
tool to adjust the monitor resolution (see
7.4.2 ScreenRes).
Contact the KUHNKE Customer Service
to get a replacement for the defective
fluorescent lamp
Install correct driver; in most cases, the
correct drivers can be obtained or downloaded
from the manufacturer's Internet
site.
No corrective action.
Ensure that the IPC is properly ventilated.
Check the ambient temperature around
the Ventura IPC.
60 E 674 GB
07.03.2007