Ventura IPC Instruction Manual pdf - Kuhnke
Ventura IPC Instruction Manual pdf - Kuhnke
Ventura IPC Instruction Manual pdf - Kuhnke
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
KUHNKE Automation Hardware<br />
3.13 <strong>Ventura</strong>+ Hardware PLC Controls<br />
3.13.1 "RESET" Button<br />
RUN<br />
STOP<br />
ERROR<br />
BUS2<br />
BUS3<br />
RESET<br />
3.14 <strong>Ventura</strong> Indicators<br />
3.14.1 Status LEDs<br />
RUN<br />
STOP<br />
ERROR<br />
BUS2<br />
BUS3<br />
RESET<br />
The Reset button is located on the front of the device, underneath the <strong>Ventura</strong>'s<br />
status indicators. The reset / cold boot will affect the <strong>Ventura</strong>+ hardware<br />
PLC only, but not the PC.<br />
To avoid it being pushed unintentionally, the Reset button can be operated<br />
using a pointed object (pen, screwdriver) only.<br />
Label LED Description<br />
RUN OFF<br />
GREE<br />
N<br />
STOP OFF<br />
RED<br />
ERROR OFF<br />
RED<br />
BUS2 OFF<br />
YEL-<br />
LOW<br />
BUS3 OFF<br />
YEL-<br />
LOW<br />
FLASHI<br />
NG<br />
PLC program not loaded, not started<br />
PLC program runs cyclically<br />
PLC program runs cyclically<br />
PLC program not loaded, not started<br />
No system error<br />
Operative controller problem<br />
Ready<br />
OK, all stations connected to bus<br />
Warning, station missing<br />
Flash code imitates address of missing station<br />
E 674 GB 29<br />
07.03.2007
Change language