Ventura IPC Instruction Manual pdf - Kuhnke

Hardware KUHNKE Automation
3.7.5 Interface "PS / 2"
2
1
4
3
6
5
3.7.6 Interface "USB1","USB2"
Ventura IPC features a PS / 2 interface that an external keyboard and/or an
external mouse can be attached to.
Connector 6-pin mini-DIN, female
Pin Signal Function
1 DAT (mouse) Data line (mouse)
2 DAT (keyboard) Data line (keyboard)
3 GND Earth
4 P5VFK +5 V (fused)
5 CLK (mouse) Clock line (mouse)
6 CLK (keyboard) Clock line (keyboard)
Shell Shield shielding
To attach a keyboard or a mouse or both to the interface, a PS2 splitter (Y
cable) is required.
The USB adapter is the port for external peripherals such as CD-ROM
drives, printers, modems or mouse and keyboard. The power supply unit for
the USB peripherals supplies up to 500 mA output current and is fused by
means of a maintenance-free "USB current-limiting circuit breaker". A short
circuit or overload thus switches off the power supply and the "USB" status
indicator lights up red.
Connector type A, male
Pin Signal Function
1 VBUS (5 VDC) +5V (fused) for external USB port
2 D- data+, USB channel 0
3 D+ data-, USB channel 0
4 GND GND for external USB port
Shell Shield shielding
The USB interfaces are made for attaching USB peripherals to. Due to the
wide range of commercially available USB units and operating systems,
KUHNKE cannot warrant that they will function properly.
The standard demands 5m as the warranted length of line. Putting in a USB
repeater you can extend lines to a maximum of 20m.
Hot Plug-ready peripherals can be attached to the USB port while the PC is
running.
To comply with the noise immunity demanded by standard IEC 61131, the
use of suitable USB cables is recommended. The accessory cables supplied
by KUHNKE Automation GmbH & Co. ( 10.7.2 Accessories) are tested for
compliance.
Wiring of all installations should bear IT-specific needs in mind.
20 E 674 GB
07.03.2007