HEMPEL

Area:
HULL MARKING
Remarks:
Specification sheet
Hempel (Denmark) A/S
Project:
DANA - DOKNING 2010 Obj. ref.: 7912680
The surface must be completely clean and dry with a temperature 3°C/5°F above the dew point to avoid condensation.
If the working procedure calls for a blast primer then use a thinned version of HEMPADUR QUATTRO in 40 - 50 microns dft.
The specified high film thickness can best be obtained by airless spray application. If another application method is used more applications are necessary to achieve the specified dry
film thickness.
Pit-corroded areas may call for an extra coat to fill out pittings.
Consult the separate APPLICATION INSTRUCTIONS for HEMPADUR QUATTRO 17634.
If the maximum recoating interval is exceeded, roughening of the surface is necessary to ensure intercoat adhesion.
Before recoating after exposure in contaminated environments, clean the surface thoroughly by (high pressure) fresh water hosing and allow to dry.
Curing agent 97334 is hazy. This is intended and has no influence on the performance.
Product information:
Mixing ratio Pot life Dry to touch Flash
Application restrictions
Shade no.
Volume
solids %
Curing
agent
volume
20°C 20°C
point
°C
VOC
g/ltr MAL Thinner
Min. Temp. Max. RH%
°C
HEMPADUR QUATTRO 17634 50630 72 97334 4 : 1 2 h 4 h 27 275 4-5 08450 -10
HEMPADUR QUATTRO 17634 22090 72 97334 4 : 1 2 h 4 h 27 270 4-5 08450 -10
HEMPATHANE TOPCOAT 55210 99990 50 95370 7 : 1 4 h 8 h 33 450 08080 -10
HEMPATHANE TOPCOAT 55210 10000 49 95370 7 : 1 4 h 8 h 33 445 4-3 08080 -10
The data, specifications, directions and recommendations (hereinafter "Information") given in this painting specification are based upon test results obtained under controlled or specifically defined conditions and said Information is correct to the
best of our knowledge. The User must satisfy itself that it is appropriate to use the Product in accordance with the Information in the actual conditions under which the Product is intended to be used, and the Manufacturer and Seller do not
guarantee the accuracy, completeness or appropriateness of the Information when the Product is used in those conditions. The provisions of Clause 8 of the GENERAL CONDITIONS OF SALE, DELIVERY AND SERVICE shall apply to any and
all claims arising out of or in connection with the use of the Product as recommended above, overleaf or otherwise.
Hempel's PreSale System 2.6.16 (Build 673)
User name:
Henrik Berg
Quality Code: 34-11 / 0710
HEMPEL
Printed at: 21.07.2010 11:35 Department name: Sales Denmark Environment : Medium
Created/Last modified: 21.07.2010 11:29 DKHEJ0181 Page: 24