Terminal block labelling - Kablo Etiketi

Tensile Tear Bonding Solubil- Properties Ingredients General
strength strength strength ity information
acc. to DIN 53455 approx. 30 % lenghtways High solvent resistance
approx. 45 N/mm² approx. 20 % crossways excellent immunity to water
chemical resistance,
good electrical properties
17 N/10 mm
9 N/25 mm
11 N/10 mm
11 N/10 mm
10 N/15 mm
Insoluble
Insoluble
As flame-retardant additives no polybromated
and polychlorinated biphenyls (PBBs
and PCBs), dibenzodioxins (PBDDs and
PCDDs), dibenzofurans (PBDFs and PCDFs)
or terphenyls (PCTs) are used
The flame-retardant system is based on an
aliphatic chlorinated salt and a small
amount of PTFE
Free from cadmium, asbestos, bromine,
lead, mercury and silicone
The material used for the ACS plates may be classified
as halogen-free under DIN/VDE 0472, Part 815.
This means a total bromine and chlorine
content < 0.2 % and fluorine < 0.1 %.
Free from cadmium, asbestos, As flame-retardant additives no polychlorinated
formaldehyde, lead, mercury biphenyls, dibenzodioxins, dibenzofurans or
and ozone-destroying terphenyls are used
substances such as halon,
CFCs and silicone
As flame-retardant additives no polybromated
and polychlorinated biphenyls (PBBs
and PCBs), dibenzodioxins (PBDDs and
PCDDs), dibenzofurans (PBDFs and PCDFs)
or terphenyls (PCTs) are used
Self-adhesive films are tested and
approved in conjunction with specific
substrates under the UL classification
“Polymer Adhesive Systems”. For this
reason all self-adhesive films should be
tested on the substrate and not just the
self-adhesive film alone.
Murrplastik Systemtechnik GmbH Postfach 1143 D-71567 Oppenweiler A +49 (0 ) 71 91/4 82-0 E +49 (0 ) 71 91/4 82-2 80 www.murrplastik.de info@murrplastik.de 183