Terminal block labelling - Kablo Etiketi

Meeting the standard
European Standard
EN 60204 (VDE 0113 Part 1) ...
... specifies that wires, components
and terminal blocks must
be clearly identified in the control
cabinet.
This identification must remain
permanently legible. The labelling
systems supplied by Murrplastik
meet all these requirements.
The Murrplastik labelling system
can be used to label single wires,
terminal blocks, control gears,
equipment locations, push-buttons
and signal lamps, and
components of all different
makes. The labelling can
be done manually using
the Ademark system; alternatively
the computeraided
ACS system can be
used. Data transfer routines for
CAD/CAE packets support the
project-specific transfer of
labelling information.
Murrplastik
is the neutral manufacturer
of labelling systems.
10 Murrplastik Systemtechnik GmbH Postfach 1143 D-71567 Oppenweiler A +49 (0 ) 71 91/4 82-0 E +49 (0 ) 71 91/4 82-2 80 www.murrplastik.de info@murrplastik.de