Equipment Recommendations : GAUIHobby - HeliFleet.com

More documents

Recommendations

Info

Tail servo and the heading hold gyro setup 1. Install the Gyro and the tail servo. 2. Connect the tail pushrod to the servo. Make sure the servo arm is 90 degrees to the tail pushrod. The ball link should be set at the second hole on the servo arm (as shown on left). 3. Slide the servo mount and the tail servo along the tail boom until the tail pitch lever is parallel to the tail output shaft or slightly forward. 4. Set the Gyro limit properly, make sure the tail pitch yoke do not touch the tail pitch lever mount and the tail rotor hub when the tail servo moves to the left and the right maximum travel volumn. If the Gyro you used do not have the function of Limit , set the function of ATV / End Point / Travel Adjust on transmitter to adjust the proper travel volumn of the tail servo. 5. If the tail oscillates or wags at less than 60% gain,you will need to move the ball link to the hole which is closer to the serve Gyro limit properly. The ideal gain setting is around 70%. Important: Do not touch the tail pitch lever mount and the tail rotor hub.
Servo and Linkage Installation Rotate each blade clockwise until the blades are parellel to the flybar. (Top View) Servo and linkage setting 1. Adjust the length of the control linkages as figure below. Make sure that the the servo arms for CCPM swashplate are all in the same length. Level 2. The servos at neutral should have the servo arms at level position, and the arm should be 90 degrees to the control linkage. At this point,the swash plate and the scissor arms should be level, and the pitch should be set at 0 degrees. Length of each linkage L1 L2 Slide the swashplate up or down until the blades are parallel to the flybar (Left View). The collective pitch angle is zero at this position. Level L3 L4 L5 30.5 mm 31 mm 25.5 mm 37.7 mm 35.3mm L1 L2 L3 L4 L5
Page 2 and 3: Electronics installation and wiring
Page 6: (maximum) + 15 degrees 0 degrees -
Page 9 and 10: M1.4X5 Ø1.4X6 IMPORTANT: Main Roto
Page 11 and 12: IMPORTANT: M2X3.2 M2X14 P2X3.5X8.5
Page 13: IMPORTANT: Distance B = Make sure t
Page 16 and 17: IMPORTANT: Shaft Driven Unit Assemb
Page 18 and 19: Specifications of Motor and ESC Spe
Page 20 and 21: M1.4X6 M2X3 Parallel (Fig.4) M2X12
Page 22 and 23: 203707 203710 203714 203718 FES 2Bl
Page 24 and 25: 203191 203196 Titanium anodized Tai
Page 26 and 27: 921601 921602 921603 922601 Micro R
Page 28: 200 V2

Equipment Recommendations : GAUIHobby - HeliFleet.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?