Equipment Recommendations : GAUIHobby - HeliFleet.com

More documents

Recommendations

Info

Specifications of Motor and ESC Specifications of 18A ESC Working Voltages(Maximum) ------------------------------ 5.5 V ~ 16.8 V(Maximum) Maximum Current(Instantaneous) -------------------------------------------------- 24 A Continual Current ------------------------------------------------------------------------ 18 A Built-in BEC ------------------------------------------------------- Maximum Input 12.6 V Output 5 V / 2 A Low Battery Protect ------------------------------------------------------ 3.1V~2.9V / cell Temperature Overload --------------------------------------------------------------- 120 ℃ Specifications of BL Motor KV value ----------------------------------------------------------------------------------- 4800 Maximum Current(Instantaneous) ------------------------------------------------- 15 A Efficiency ---------------------------------------------------------------------------------- 85% Voltage Range -------------------------------------------------------------------- 7 V ~ 15 V Motor Weight ---------------------------------------------------------------------------- 28 g Motor Diameter ------------------------------------------------------------------- 24.5 mm Motor Length ------------------------------------------------------------------------ 24 mm Motor Output Shaft Diameter ----------------------------------------- 2.3x12 (L) mm Bearings ------------------------------------------------ (3x6mm)*1 pc , (3x7mm)*1 pc Poles -------------------------------------------------------------------------------------------- 8
GU-365 FES Gyro installing 1.Cut the sponge tape into 4 small squares (8mm), attached them to the corners of name plate side. Gyro must not be tied 2.Attach the GU-365 Gyro to heli as shown in figure above. Battery Use the magic tape to attach the battery onto battery plate (bottom side), and it is re<strong>com</strong>mended to tie them together by Rubber Band or Touch Fastener Cable Tie. (AIL)Servo (PIT)Servo Receiver Wires must not be pulled tightly Gyro box must not have contact with heli except sponge tape 3.The trimmers and switches of GU-365 Gyro should be aligned with the slots. CA (ELE)Servo 18A ESC GU-365 FES Gyro Use C/A to adhere frames and bottom plate which may avoid vibration IMPORTANT: Please refer to the instruction manual of GU-365 gyro for more setting information.
Page 2 and 3: Electronics installation and wiring
Page 4 and 5: Tail servo and the heading hold gyr
Page 6: (maximum) + 15 degrees 0 degrees -
Page 9 and 10: M1.4X5 Ø1.4X6 IMPORTANT: Main Roto
Page 11 and 12: IMPORTANT: M2X3.2 M2X14 P2X3.5X8.5
Page 13: IMPORTANT: Distance B = Make sure t
Page 16 and 17: IMPORTANT: Shaft Driven Unit Assemb
Page 20 and 21: M1.4X6 M2X3 Parallel (Fig.4) M2X12
Page 22 and 23: 203707 203710 203714 203718 FES 2Bl
Page 24 and 25: 203191 203196 Titanium anodized Tai
Page 26 and 27: 921601 921602 921603 922601 Micro R
Page 28: 200 V2

Equipment Recommendations : GAUIHobby - HeliFleet.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?