Equipment Recommendations : GAUIHobby - HeliFleet.com

More documents

Recommendations

Info

Double Joints Tail Slider & CNC Tail Gear Case Assembling IMPORTANT: Make sure to use the non-locktite adhesive or similar material to adhere the screws while assemble the parts. Upper tail pitch lever The bearings and the tail pitch link should be adhered by the locktite adhesive. Vertical B1.5X3.4X2 P2X2.5X4.6 M1.4X3 #203135 N2X4 M2X8 M1.4X5 M1.4X5 W3X4.6X0.5 P1.4X2.5X1.24 P1.2X3.5 M1.4X6 B1.4X4X2 B3X6X2 M1.4X5 P2X3X7.7
IMPORTANT: Distance B = Make sure to use the non-locktite adhesive or similar material to adhere the screws while assemble the parts. 4.5mm Use Locktite 609 , 680 , or similar material to adhere the long neck pinion gear to the motor shaft. ( Make sure the distance B is correct. ) M3X3 64T B3X7X2 B3X6.5X6 120T Belt Driven Unit Assembling-1 15T Motor can be mounted front or rear M3X5 #203232
Page 2 and 3: Electronics installation and wiring
Page 4 and 5: Tail servo and the heading hold gyr
Page 6: (maximum) + 15 degrees 0 degrees -
Page 9 and 10: M1.4X5 Ø1.4X6 IMPORTANT: Main Roto
Page 11: IMPORTANT: M2X3.2 M2X14 P2X3.5X8.5
Page 16 and 17: IMPORTANT: Shaft Driven Unit Assemb
Page 18 and 19: Specifications of Motor and ESC Spe
Page 20 and 21: M1.4X6 M2X3 Parallel (Fig.4) M2X12
Page 22 and 23: 203707 203710 203714 203718 FES 2Bl
Page 24 and 25: 203191 203196 Titanium anodized Tai
Page 26 and 27: 921601 921602 921603 922601 Micro R
Page 28: 200 V2

Equipment Recommendations : GAUIHobby - HeliFleet.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?