7900 Instrument Stand - Haag-Streit USA
7900 Instrument Stand - Haag-Streit USA
7900 Instrument Stand - Haag-Streit USA
- TAGS
- haag-streit-usa.com
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
8<br />
mounting tabs then lift the console out from the front of the<br />
unit.(See Figure2)<br />
To install a console, connect the four connectors on top of<br />
the base to the matching connectors hanging from the back<br />
of the console. The lamp jumper cable will drop throught the<br />
large opening and be connected to the matching connector<br />
that hangs from underneath the support column. Figure 2<br />
illustrates the connections that must be made. Align the three<br />
mounting tabs in the base unit with the matching holes in the<br />
console and attach with Phillps Head screws.<br />
2.3. support Column installation<br />
Remove Philips Head shipping screw. Unwrap the support<br />
column. Remove the column support pin and the collar from<br />
the instruction manual bag. Insert the column in the hole at<br />
Chair Control<br />
(Ref)<br />
Overhead<br />
Lamp<br />
Slit Lamp<br />
Arm from<br />
Roller Frame<br />
Mounting<br />
Tabs<br />
Ground from<br />
AC Input<br />
Figure 2<br />
Ground from 3rd Arm &<br />
Slit Lamp<br />
AC Input<br />
from Outlet<br />
Plate<br />
3rd Arm<br />
from Back<br />
Cover<br />
Aux from<br />
Back Cover<br />
the top of the base unit. Line up the hole in the column with<br />
the hole in the base unit and insert the pin. Note that the<br />
small screw at the top of the column faces the rear of the<br />
unit. Tighten the set screws under the support pin. Remove<br />
set screw from bag and install where shipping screw had<br />
been. Slide the collar down firmly against the console/base<br />
cap. Insert and tighten set screw.<br />
2.4. Configuring The switches For The b/P<br />
Switchpack SW2 on the console must be configured<br />
for proper operation of the stand. Individual switches 1,<br />
2 and 3 control the voltage and power to the Indirect<br />
Ophthalmoscope. See Table 1 on Page 8.<br />
Switchpack<br />
(SW2)<br />
Overhead<br />
Lamp<br />
Overhead<br />
Lamp<br />
Jumper<br />
B/P Jumper<br />
from Module<br />
Chair Control<br />
from Outlet<br />
Plate<br />
Switchpack<br />
(SW1)<br />
Optional<br />
Chair<br />
Control<br />
IN-<strong>7900</strong>