7900 Instrument Stand - Haag-Streit USA

More documents

Recommendations

Info

20 installation Diagram: Dual Zone Flourescent On/OFF incandescent 120 VaC or 277 VaC Resistor needs to be mounted. Recommended box to house relay and resistor- 6” x 6” x .04” thick and made of aluminum. note: See Grafik Eye for installation of GRX. Figure 13 note : Voir l’oeil diagramme pour l’installation de GRX. IN-<strong>7900</strong>
Warning-The eCliPse inFrareD rOOm lighTs COnTrOl sYsTem musT maTCh The reQuiremenTs OF The user. iF The sYsTem is nOT PrOPerlY COnFigureD beFOre seCOnDarY POWer TO The uniT is TurneD On Via The sTbY sWiTCh, Damage TO The sYsTem Or insTrumenT bulbs maY OCCur. aVerTissanT-le sYsTÈme De COnTrôle inFrarOuge D’ÉClairage ÉCliPse DOiT COrresPOnDre aux COnDiTiOns De l’uTilisaTeur. si le sYsTÈme n’esT Pas COrreCTemenT COnFigurÉ aVanT D’allumer le suPPOrT OPhTalmiQue, Par le COnTrôle “sTbY”, Des DOmmages au suPPOrT Ou aux amPOules ÉleCTriQues PeuVenT se PrODuire. ECLIPSE ROOM LIGHT SYSTEM Press Here to turn oFF indireCt BulB ratings slit lamP BulB ratings sW2-1 sW2-2 sW2-3 Hanger BeeP on oPen sW2-7 sW2-8 Press Here to turn on oFF sW2 REAR VIEW OF CONSOLE ASSEMBLY eCliPse inFrareD rOOm lighT COnTrOls PrOgramming guiDe Configuring the system is accomplished by setting dip switches found on the circuit board. The dip switches are labeled SW1 and SW2. The following paragraphs provide the necessary information required to configure the system. sWiTChPaCk #1 (sW1) switch 1 • Turn Switch 1 OFF if your system contains a single-zone infrared receiver. • Turn Switch 1 ON if your system contains a dual-zone infrared receiver (Factory default setting). 1 2 3 4 5 6 7 8 oFF sW1 1 2 3 4 5 6 7 8 enaBle-on dual Zone Well #1 Well #2 Well #3 Binding Post s/l arm auXiliary lamP switch 2 • Turn Switch 2 ON to enable Well #1 to affect room lights and fixation lights. • Turn Switch 2 OFF to disable Well #1 from affecting room lights and fixation lights. switch 3 • Turn Switch 3 ON to enable Well #2 to affect room lights and fixation lights. • Turn Switch 3 OFF to disable Well #2 from affecting room lights and fixation lights. switch 4 • Turn Switch 4 ON to enable Well #3 to affect room lights and fixation lights. • Turn Switch 4 OFF to disable Well #3 from affecting room lights and fixation lights. switch 5 • If power to the Indirect Ophthalmoscope is controlled by the B/P Switch on the front panel, turn Switch 5 ON if you want the B/P Switch to affect room lights. • Turn Switch 5 OFF if you do not want the B/P Switch to affect room lights. switch 6 • Turn Switch 6 ON to enable Slit Lamp Arm Switch to affect room lights. • Turn Switch 6 OFF to disable Slit Lamp Arm Switch from affecting room lights. switch 7 • Turn Switch 7 ON to enable the AUX1 Switch to affect room lights. • Turn Switch 7 OFF to disable the AUX1 Switch from affecting room lights. switch 8 • Turn Switch 8 ON to enable the LAMP Switch to affect room lights. • Turn Switch 8 OFF to disable the LAMP Switch from affecting room lights. IN-<strong>7900</strong> 21
Page 1 and 2: ��INSTALLATION AND OPERAT
Page 3 and 4: Table of Contents imPOrTanT inFOrma
Page 5 and 6: 1. inTrODuCTiOn 1.1. This Installat
Page 7 and 8: 2. insTallaTiOn 2.1. unpacking 2.1.
Page 9 and 10: TABLE 1 SWITCH SETTINGS FOR B/P VOL
Page 11 and 12: Figure 4a Figure 4b Figure 4C Figur
Page 13 and 14: 3. OPeraTing insTruCTiOns 3.1. slit
Page 15 and 16: CauTiOn- The lamp inside the instru
Page 17 and 18: 3.6.2 • The round button under th
Page 19: 3.8.2 incandescent vs. Fluorescent
Page 23 and 24: oom switch (rOOm) • Dual Zone tur
Page 25 and 26: P/N 17185 0.22 Figure 18 single ZOn
Page 27 and 28: P/N 17187 Figure 20 FluOresCenT inT
Page 29 and 30: TrOubleshOOTing guiDe insTrumenT sT
Page 31 and 32: Cleaning Painted surfaces The paint
Page 33 and 34: (nOTes) IN-7900 33
Page 35 and 36: 19 14 21 Figure 22 mODel 7900 insTr
Page 37 and 38: item part no. description item part
Page 39 and 40: item part no. description 1 1627295
Page 61 and 62: IN-7900 61
Page 63 and 64: IN-7900 63
Page 65 and 66: (NOtES) IN-7900 65
Page 67 and 68: limited warranty the reliance® pro

7900 Instrument Stand - Haag-Streit USA

Create successful ePaper yourself

Delete template?

Save as template?