Panasonic FP Series PLC Programming Manual - CTi Automation

1.1 Table of Relays, Memory Areas and Constants
Item
Numbering
Function
Constant Decimal
constants t t
Hexadecimal
constants t t
Floating g ppoint
ttype pe
Notes
C10/C14
/C16
C32/SL1 T32C
(K) ( ) K−32768 to K32767 (for 16-bit operation)
K−2147483648 to K2147483647 (for 32-bit operation)
(H) ( ) H0 to HFFFF (for 16-bit operation)
H0 to HFFFFFFFF (for 32-bit operation)
(F) F−1.175494×10−38 to F−3.402823×1038 ( )
F1.175494×10 −38 to F3.402823×10 38
1) The points for the timer and counter can be changed by the
setting of system register 5. The numbers given in the table
are the numbers when system register 5 is at its default
setting.
2) There are two unit types, the hold type that saves the
conditions that exist just before turning the power off or
changing form the RUN mode to PROG. mode, and the
non−hold type that resets them. For the FP0 T32C, the
selection of hold type and non−hold type can be changed by
the setting of system register. These areas can be spcified as
hold type or non−hold type by setting system register. For the
FP0 C10/C14/C16/C32/SL1, that area is fixed and allotted the
numbers as shown below.
Hold type and Non-hold type areas
Item C10/C14/C16 C32/SL1
Timer Non−hold type: All points
Counter Non-hold type From the set value to C139 From the set value to C127
Hold type 4 points (elapsed values) 16 points (elapsed values)
(C140 to C143)
C128 to C143
Internal Non-hold type 976 points
880 points
relay
(R0 to R60F)
(R0 to R54F)
61 words
55 words
(WR0 to WR60)
(WR0 to WR54)
Hold type 32 points (R610 to R62F) 128 points (R550 to R62F)
2 words (WR61 to WR62) 8 words (WR55 to WR62)
Data Non-hold type 1652 words
6112 words
register eg s e
(DT0 to DT1651)
(DT0 to DT6111)
Hold type 8 words
32 words
(DT1652 to DT1659) (DT6112 to DT6143)
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
1-3