TUNING LEVERS - Schaff Piano Supply Co.

REGULATING TOOLS
REGULATING SCREWDRIVER
This tool has a very unique design in that the 3/8” diameter
ball end has crossing, oval openings that allow regulating eye
screws to be turned at any 90° angle. The guesswork of
locating regulating screws is eliminated with this tool.
Overall length is 8”, chrome plated and fits our No. 26
Combination Handle.
No. 269 - Regulating Screwdriver. Each
POINTED AWL
This hardened steel awl has a sharp three cornered point
for making pilot holes for wood screws, holes in leather,
etc. 1/8” shank, 5” long.
No. 3111 - Pointed Awl. Each
DAMPER SCREW REGULATOR
An ingenious tool with a finder designed to fit over damper
screws for ease of regulation. The recessed screwdriver blade
is 3/16” long. Regulator is 8” and chrome plated.
No. 4107 - Damper Screw Regulator. Each
RATCHET GRAND JACK SCREW REGULATOR
With it’s ratchet design, this 6” long, nickel plated
tool increases the speed of adjustment for “eye”
type regulating screws.
No. 144 - Ratchet Jack Screw Regulator. Each
UPRIGHT BACKCHECK BENDER
7” long, an excellent tool for bending upright backchecks.
No. 3104 - Upright Backcheck Bender. Each
UNIVERSAL ACTION REGULATOR
6-1/2” long.
No. 3157 - Universal Action Regulator. Each
ACTION REGULATOR
Used for bending various wires in action regulating. The tool
has slot openings measuring 3/32” wide, an overall length of
10-1/2”, a 3-1/2” wooden handle and a 3/16” diameter,
nickel plated shaft.
No. 143 - Action Regulator. Each
ACTION REGULATING TOOL
For bending wires in action regulating. 9-1/2” long,
notched for combination handle.
No. 3135 - Action Regulating Tool. Each
ACTION REGULATING TOOL
Particularly useful for bending wires when regulating drop
actions. 11” long.
No. 3136 - With Permanent Wood Handle Attached. Each
No. 3137 - Notched for Combination Handle. Each
GRAND DAMPER HOOK
This tool is designed to come up under the strings over the
guide rail, and fit around the damper wire near the damper
head for precise regulation. The damper hook has a 5/64”
slot, a 3/16” diameter, chrome plated shaft and is 12”
overall length.
No. 93 - Grand Damper Hook. Each
KEY BALANCE HOLE BURNISHER
Used with a combination handle, this specially tapered
tool is designed to be inserted from the top, bushing side of
the key so that the balance hole can be properly sized. Tool
has a 1/8” shaft flared to 3/16” and then tapered to a point.
Overall length is 4”, chrome plated.
No. 43 - Key Balance Hole Burnisher. Each
BALANCE PIN HOLE REAMER
Fits through the key button, and permits reaming the
balance pin hole with the cutting edges.
No. 3156 - Balance Pin Hole Reamer. Each
UPRIGHT FLANGE SPACER
Measuring 9” overall with a 1/4” diameter shaft and an
11/16” wide blade, this tool is designed for lining up upright
butt and whippen flanges. Polished steel.
No. 65 - Upright Flange Spacer. Each
43