CT8 XO Mk2 Manual - Bowers & Wilkins

CT8 DS Only
Installation to wall surface only. (figure 13)
Using the front aspect template provided, mark the centre line of the
retaining bracket on the wall.
The two angle brackets (figure 12 - A) from the kit are not required.
Offer the wall bracket (C) to the wall and mark the screw positions at each
end.
Drill and plug the wall to take screws in the range 5mm - 6mm (No.10 to
No.12)
Screw the wall bracket to the wall, trapping the stud plate (B) in position.
12
Figure 13
Figure 12