Compressors / compressed air - Aircraft

Compressed air filter
ClEARPoInT ® compressed air filter
An innovative concept, convincing in the detail
The thread connection of the CLEARPOINT ®
compressed air filter are larger dimensions.
Energy-consuming neckings are therefore part of
the history. Also in the combination of several
CLEARPOINT ® compressed air filters, the full crosssection
will be maintained.
Up to 75 % less resistance, higher
profitability. The new flow-optimized inlet
helps you to safe on money.
CLEARPOINT ® Filter elements are being used
without cross-section reducing and disturbing
tie rods. On the one hand it reduces the flow
resistance and in furthermore reduces the space
which is required to replace the elements to
one third - this is particularly advantageous for
cramped spaces. The innovative Push-Fit design
of the elements allows simple and
quick replacement.
The hollow room volume of the borosilicate
filter material of 96% provides for least loss of
pressure. Usual filter material made of sintered
polyethylene only possesses a hollow room
volume of 45%. This way, the free cross-section
surface for CLEARPOINT ® filters is double
compared to common filters for the following
through.
Common filter media are often hydrophilic: The
fibres are swelling and are this way reducing the
available hollow room volume. Consequently the
filters are clogging and the loss of pressure is
increasing by which also the operating cost are
increasing.
The material of the CLEARPOINT ® filter elements is
therefore waterproofed by default.
Flow resistance of an angle
at equivalent tube lengths in m
Connection 3/8“ 1/2“ 3/4“
Sheet, R=d 0,2 0,3 0,3
Angle, 90° 0.8 1.0 1.2
CLEARPOINT ® Other makes
Information:
The compressors are taking in dirt particles,
hydrocarbons and micro fine dust together with
the environmental air. This way, a large part of the
harmful substances is arriving in the compressed air.
However, most applications require pure compressed
air. AIRCRAFT ® is offering the appropriate
compressed air filter
optimum
coating
for ClEARPoInT ®
Aluminium Aluminium Aluminium Sea water
chrome-plated KTL resistant
coated aluminium
anodized
The coating of ClEARPoInT ® filter housings
The condensate which is dropping out during the
compressed air filtration
is almost in any case aggressive so that the
unprotected housings will corrode. CLEARPOINT ®
filter housings are made of water-resistant
aluminium and in addition anodized at the inside.
This will increase the operational reliability, since
corrosion can not take place on the clean air
side. In addition the continuously smooth surface
reduces the flow resistance.
The safe locking mechanism offers a 100% control
when opening the filter housing. If the housing
is opened up under pressure, a warning signal
resounds.
The needle felt drainage layer
which is installed by default is thermally highresistant
compared to the foam used for other
filter models (up to 120°C), mechanically high
resilient, chemically resistant and in addition
silicone-free. Connected with the stable
construction of the filter element it is not possible
that the draining layer would blow up or break.
The continuous of the whole filter surface is being
guaranteed.
106 Built according to CE directives
Confirmation in the salt spray test (DIN 50021)
1000 h
800 h
600 h
400 h
200 h