using the bootstrap loader
using the bootstrap loader
using the bootstrap loader
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CONFIGURING THE THIRD STAGE<br />
where:<br />
type The type of processor board in your system. The following are <strong>the</strong> valid<br />
values:<br />
Processor Board<br />
iSBC 286/10 board<br />
iSBC 286/1 OA board<br />
iSBC 286/12 board<br />
iSBC 386/12 board<br />
iSBC 286/ 100A board<br />
iSBC 386/2X board or iSBC 386/3X Board<br />
iSBC 386/116 board or iSBC 386/120 Board<br />
4.3.9 %INSTALLATION Macro (BG3.AS6 Only)<br />
4-14<br />
286/12<br />
286/12<br />
286/12<br />
386/12<br />
286/100A<br />
386/20<br />
386/100<br />
The %INSTALLATION macro specifies whe<strong>the</strong>r <strong>the</strong> generic third stage will enter <strong>the</strong><br />
monitor after loading <strong>the</strong> application system or not. The syntax of <strong>the</strong> %INSTALLATION<br />
macro is:<br />
where:<br />
%INSTALLATION (monitor_entry)<br />
monitor_entry The type of action <strong>the</strong> Bootstrap Loader is to take upon<br />
loading <strong>the</strong> application system. If monitor entry is 'n' <strong>the</strong><br />
system loads and <strong>the</strong>n executes with no monitor entry in<br />
between. If it is 'y', <strong>the</strong> monitor is entered after <strong>the</strong><br />
system loads. You must type in <strong>the</strong> monitor GO<br />
command to continue.<br />
When <strong>the</strong> monitor is entered, as a result of specifying 'y' for <strong>the</strong> monitor entry parameter,<br />
<strong>the</strong> Bootstrap Loader prints <strong>the</strong> following message to <strong>the</strong> terminal instructing you how to<br />
proceed with <strong>the</strong> loading:<br />
Insert <strong>the</strong> Start-up System Commands Diskette and type "G"<br />
This is an example. The actual message will differ according to <strong>the</strong> type of system you are<br />
booting.<br />
NOTE<br />
If your system has <strong>the</strong> D-MON386 monitor ra<strong>the</strong>r than <strong>the</strong> iSDM monitor, type<br />
"GO < RETURN>" instead of "G < RETURN>.<br />
Bootstrap Loader