UMC 112 - Trend Product Marking Systems Australia
UMC 112 - Trend Product Marking Systems Australia
UMC 112 - Trend Product Marking Systems Australia
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1 General Guidelines for maintenance<br />
1.1 Maintenance overview<br />
Note<br />
Unprofessional usage of controls or marking head voids the warranty.<br />
General guidelines for maintenance:<br />
• With all adjustments, maintenance and repair works, the control must<br />
always be switched off and the marking unit must be separated from the<br />
power supply. For that purpose, pull the power supply plug before opening<br />
the unit. Exceptions of it, with which the unit must remain switched on<br />
during appropriate work, are noted in the maintenance instructions in each<br />
case.<br />
• With work on pneumatics:<br />
- Turn off and lock the compressed air supply.<br />
- Wait at least 5 s after turning off the compressed air supply, until the<br />
pressure diminishes itself.<br />
- Examine whether the operating pressure dropped on 0 bar. Read off<br />
the current operating pressure from the appropriate manometer.<br />
Operating hours Maintenance place Maintenance work Page<br />
40 Ventilation of the control Check the air filter on dirt, clean or change it if necessary 5-5<br />
40 Slides of the axes<br />
(coining unit)<br />
500 Slides of the axes<br />
(engraving unit)<br />
Check the slides on smooth running 5-9<br />
Lubricate the lubricating nipple 5-10<br />
1000 Ventilation of the control Change the air filter 5-5<br />
2000 Exhaust air silencer Clean the silencer, change it if necessary 5-6<br />
2000 Slides of the axes<br />
(engraving unit)<br />
If necessary Toothed belts of the<br />
axes (coining unit)<br />
If necessary Toothed belts of the<br />
axes (coining unit)<br />
If necessary Slides of the axes<br />
(engraving unit)<br />
If necessary Pneumatic maintenance<br />
unit<br />
Change the automatic grease cartridge (option) 5-10<br />
Check the toothed belts on wear<br />
Check the tension of the toothed belts<br />
B_PM_<strong>UMC</strong><strong>112</strong>_en05.doc<br />
5-2 Maintenance ÖSTLING Markiersysteme GmbH<br />
5-7<br />
Change the toothed belts 5-8<br />
Adjust the tightness 5-11<br />
Adjust the oiler 5-15<br />
Tab. 1