UMC 112 - Trend Product Marking Systems Australia

Load mask
Error
With this function a mask is called up via the serial port. The mask to be called
must be already stored on the control. To load a mask, the following data must
be sent:
1. Byte 2. Byte 3. Byte 4. Byte 5. - 16. Byte 7. Byte 8. Byte
HEX 01h 4Dh 4Ch 1Ah 12 Bytes 17h 04h
DEC 01 77 76 26 23 04
ASCII SOH 'M' 'L' SUB TEST .MSK ETB EOT
Start of
header
Mask Laden Substitute
File name of the
mask e. g.
'Test.msk'
End of
transfered
block
End of
transfer
Tab. 5
Note
The file name must be filled with spaces up to 8 characters ahead of the point.
After error-free reception of the data the control sends the following:
1. Byte 2. Byte 3. Byte 4. Byte 5. - 16. Byte 7. Byte 8. Byte
HEX 01h 4Dh 4Ch 06h 12 Bytes 17h 04h
DEC 01 77 76 06 23 04
ASCII SOH 'M' 'L' ACK TEST .MSK ETB EOT
Start of
header
Mask Laden Acknowledge
File name of the
mask e. g.
'Test.msk'
If the mask isn't available, the control sends the following:
End of
transfered
block
End of
transfer
Tab. 6
1. Byte 2. Byte 3. Byte 4. Byte 5. - 16. Byte 7. Byte 8. Byte
HEX 01h 30h 35h 15h 12 Bytes 17h 04h
DEC 01 48 53 21 23 04
ASCII SOH '0' '5' NAK TEST .MSK ETB EOT
Start of
header
Incoming byte in
hexadecimal format
No acknowledg
ment
File name of the
mask e. g.
'Test.msk'
If the received header is defective, the control sends the following:
End of
transfered
block
End of
transfer
Tab. 7
1. Byte 2. Byte 3. Byte 4. Byte 5. - 16. Byte 7. Byte 8. Byte
HEX 01h 30h 31h 15h 12 Bytes 17h 04h
DEC 01 48 49 21 23 04
ASCII SOH '0' '1' NAK TEST .MSK ETB EOT
Start of
header
Incoming byte in
hexadecimal format
No acknowledg
ment
File name of the
mask e. g.
'Test.msk'
End of
transfered
block
End of
transfer
Tab. 8
B_PM_UMC112_en06.doc
6-6 Communication ÖSTLING Markiersysteme GmbH