The Army Maintenance Management System (TAMMS) Users Manual

Legend for Figure 3–17;
completion instructions follow. Use either the blocks at the top or the bottom of the card. Enter the last two digits of the calendar year in
the shaded box at the upper left or lower left of the card.
REGISTRATION NUMBER. Enter the registration number, if the equipment has one assigned, or the serial number. Ink entry.
ADMINISTRATION NO. Enter the equipment’s administration number (bumper or locally assigned number). If the equipment does not
have an assigned administration number (bumper or locally assigned number), pencil, none assigned in this block.
NOMENCLATURE. Ink entry.
1. Enter the noun abbreviation in this block.
2. Enter the word, Equip End Item below the noun.
3. Place the ECC and LIN under the words, Equip End Item. ECCs are available in table B–18. LINs are in the FED LOG. Use the exact
nomenclature format listed in the FED LOG.
MODEL. Enter the model number; for example, M1009. Use the exact model format listed in AR 700–138. Ink Entry.
ASSIGNED TO. Enter the name of the unit or organization owning the equipment in pencil.
REMARKS. In pencil, annotate any maintenance information that is needed in the future or on the replacement form for the next year.
This information may include service symbols, dates for current and next year, and warranty information. If the equipment is under
warranty, print in pencil “Warranted Item” and the length of the warranty in miles, months, hours, or years. The Warranty Control Office
or Logistics Assistance Office can assist with warranty data for specific pieces of equipment. Use it when filling out DA Form 2407.
1. Antifreeze entries are made in the Remarks block for equipment under warranty or using commercial or arctic antifreeze. For
additional information, see TB 750–651.
2. Cooling systems serviced with antifreeze, Mil–A–46153, require the degree of protection, the condition of the cooling system, and the
use of antifreeze extender, Mil–A–53009, recorded in this block. See TB 750–651. PMCS reference, PMCS time, and flight check data
are shown for all ATC equipment.
DATE RECEIVED. Leave blank or use as needed locally.
RECEIVED FROM. Leave blank or use as needed locally.
DISPOSITION. Leave blank or use as needed locally.
DATE BLOCKS. Indicate services scheduled with pencil entries and services completed with ink pen entries.
Figure 3–17. Sample DD Form 314 used for equipment end item
DA PAM 750–8 22 August 2005
71