The Army Maintenance Management System (TAMMS) Users Manual

Legend for Figure 3–10;
completion instructions follow.
1. SUPPORT AGENCY UIC. Enter the UIC of the support activity that receives, holds, or works on the item.
2. DATE. Enter the Julian date the form was initiated.
3. ORGANIZATION UIC. Enter the UIC of the owning unit or organization.
4. WARRANTY/EIR EXHIBIT/TMDE/OTHER. Mark the block to show the use of the form. If form is being used for other, print the use of
the form at the bottom of block 2 Date below the Julian date.
5. NSN. Enter the NSN of the item.
6. NOUN NOMENCLATURE. Print the noun abbreviation of the item to be repaired.
7. PD. Enter the priority designator (PD) that applies to the action. The unit or organization listed in block 3 normally assigns the PD.
When the form supports a customer maintenance request, use the PD of the maintenance request.
8. PD AUTHENTICATION. The commander or the commander’s designated representative signs when a PD of 01 through 08 is in block
7.
9. END ITEM NOUN NOMENCLATURE. Enter the noun nomenclature of the end item or end item from which the component came.
10. MODEL. Enter the model of the end item or end item from which the component came.
11. SERIAL NO. Enter the serial number of the end item or end item from which the component came.
12. DEFICIENCY OR SYMPTOM. Enter the deficiency or symptom that caused this maintenance transaction to occur.
Blocks 13-19. To be filled in by the maintenance support unit.
13. DATE ACCEPTED. Enter the Julian date when the item was accepted.
14. SIGNATURE. The shop office representative or inspector responsible for repairs signs here.
15. NMCS. Enter yes or no if this part of the component causes the end item to be not mission capable.
16. WON. Enter the work order number that was submitted with the item.
17. INITIALS. The shop foreman enters his/her initials validating that the information on the form is correct and accepting the item.
18. DATE REPAIRED. Enter the date that the repair is completed or the warranty claim or EIR exhibit are released.
19. INITIALS. The shop foreman enters his/her initials when the repairs have been completed or the warranty claim or EIR exhibit are
released.
Figure 3–10. Sample DA Form 2402
64 DA PAM 750–8 22 August 2005