The Army Maintenance Management System (TAMMS) Users Manual

Table B–21
Work request status code—Continued
9 Begin in-transit time
Notes:
1 These codes indicate the status of a work request in the maintenance shops at all levels. These codes are applicable to all SAMS and ULLS forms which
have a STA block. The following describes the usage and rules of each code:
Table B–22
Work request NMC indicator codes
Code Description
2 Stops NMC time. Item remains in the maintenance activity for non-NMC work, for example, painting. Must be followed by a
valid work request status code.
3 Restart NMC time. Must be preceded by a "2" (which stops NMC time). Must be followed by a valid work request status
code.
Notes:
1 These codes are maintenance indicator codes that denote the NMC status of a work request in the maintenance shops. These codes are only used with
work orders that have a "0" or "2" in the sixth position of the ORG WON that identify reportable inoperative equipment. A "0" denotes reportable ground or
missile equipment, and "2" denotes reportable aircraft. These codes are applicable to all SAMS forms which have a STA block, and are intended to provide
units and higher headquarters with timely AMSS status. These codes are SAMS unique and are not required for non-automated units.
Table B–23
NMC time for AMSS reporting
Unit-Level ULLS Support-Level SAMS
Status Codes NMCM NMCS NMCD NMCE NMCM NMCS NMCD FMC
A 2 X X
B 2 X X
C 2 X X
D 2 X
E 2 X X
F 2 X X
G X X
H X
I 2 X X
J 2 X X
K X
L X
M 2 X X
N 2 X X
O 2 X X
P X
Q X
R X X
S X X
T X X
U 2 X
V X X
W X
DA PAM 750–8 22 August 2005
237