The Army Maintenance Management System (TAMMS) Users Manual

INSTALLATION. Assigned location.
A—OPERATORS REPORT
ITEM NUMBER. List in numerical sequence.
REPAIRS NEEDED (Reported by Road Inspector or Operator). Describe the fault or problem.
CORRECTED (Mechanics Initials). Qualified mechanics initials.
1. CLEAN UNIT. Mark yes or no.
2. LUBE OIL PRESSURE: NUMBER 1/NUMBER 2. Enter OK if engine lube oil pressure is normal as specified by manufacturer after
initial warm up. If defective, enter DEF and explain the problem in the Remarks block on backside of form.
3. WATER TEMPERATURE: NUMBER 1/NUMBER 2. Enter OK if engine temperature is normal as specified by the manufacturer after
initial warm up. If defective, enter DEF and explain problem in Remarks block on backside of form.
4. BATTERY AMMETER: NUMBER 1/NUMBER 2. Enter OK if charging. If defective, enter DEF and explain problem in REMARKS block
on backside of form.
5. LOAD METER: NUMBER 1/NUMBER 2. If operational, enter OK. If defective, enter DEF and explain problem in Remarks block on
backside of form.
6. MAIN RESERVOIR PRESSURE. Enter PSI for main reservoir pressure.
7. EQUALIZING RESERVOIR PRESSURE. Enter PSI for equalizing reservoir pressure.
8. BRAKE PIPE PRESSURE. Enter PSI for brake pipe pressure.
9. CONTROL AIR PRESSURE. Enter PSI for control air pressure.
SIGNATURE OF ROAD INSPECTOR. Leave blank.
SIGNATURE OF OPERATOR. Sign name legibly.
B—MAINTAINER’S REPORT. Read all items 1 through 27.
ITEMS.
CHECK ONE: OK/DEFECTIVE. Make check mark in OK or defective blocks.
CORRECTED (Mechanics Initials). Enter initials of qualified mechanic doing the work.
C—ADDITIONAL WORK OR OTHER QUALIFYING DATA
REMARKS. Note any work done that was not listed in B. Note information for future use.
D—AUTHENTICATION
SIGNATURE OF INSPECTOR. Signature of qualified rail inspector.
SIGNATURE OF FOREMAN. Signature of foreman.
Figure 7–1. Sample DD Form 862 (back)—Continued
DA PAM 750–8 22 August 2005
175