The Army Maintenance Management System (TAMMS) Users Manual

Projectile Type b. Leave blank.
Zone or Charge c. Leave blank.
Rounds Fired d. Leave blank.
EFC RDS Fired e. Leave blank.
Cumulative RDS Fired f. Enter the total rounds fired from the last entry in column 10f of the form to be sent in.
Cumulative EFC RDS g. Enter the total EFC rounds fired from the last entry in column 10g of the form to be sent in.
Remaining Life (EFC RDS) h. Enter the remaining life. Make sure this number matches the last entry in column 10h of the previous DA
Form 2408–4.
Remarks i. Transfer any needed remarks from the previous form. For example, enter the date of the last borescope, special maintenance
inspection, last pullover gauge reading, calibration (VE) and Recoil Exercise (R.E.).
Signature j. The unit commander signs in this column on the first line and last line entries. The unit commanders signature shows that all
the information has been checked on the previous form and is correct. It also means all current and needed information has been
transcribed to a new DA Form 2408–4.
Figure 5–2. Sample DA Form 2408–4 with information to keep when sending a DA Form 2408–4
Legend for Figure 5–3;
completion instructions follow.
1. TUBE SERIAL NUMBER. Leave blank.
2. CANNON TYPE MODEL OR SERIES. Leave blank.
3. ORGANIZATION (UIC). Enter the Unit Identification Code (UIC).
4. SPECIAL LIFE DATA. Leave blank.
5. END ITEM IDENTIFICATION. Enter the weapon and item identification, type series and model.
6. RDS/EFC COMPUTATIONS. Leave blank.
7. CANNON SERIAL NUMBER. Leave blank.
8. RETUBINGS. Leave blank.
9. REBUSHINGS. Leave blank.
10. This block is divided into columns a through j:
Date a. Write the calendar date when the action occurred.
Projectile Type b. Enter the type of projectile and cartridge model.
Zone or Charge c. Leave blank.
Rounds Fired d. Leave blank.
Figure 5–3. Sample DA Form 2408–4 used for boresight and zero
144 DA PAM 750–8 22 August 2005