The Army Maintenance Management System (TAMMS) Users Manual

SECTION VI—COMPLETION DATA.
29. QTY RPR. Enter quantity of items repaired.
30. QTY CONDEMN. Enter quantity of items condemned.
31. QTY NRTS. Enter quantity of items not repairable at the repair activity.
32. EVAC WON. If item is evacuated, enter work order number assigned by receiving maintenance unit.
33. EVAC UNIT NAME. Enter name of unit to whom item is evacuated.
SECTION VII—ACTION SIGNATURES.
34a-b. To be completed by unit requesting maintenance.
35a. ACCEPTED BY. Block 35a is filled out only when the onsite repair is started or the deferred item is brought back. The person
accepting the work order enters first initial and last name in this block.
35b. STATUS. Enter the work request status code. Table B–21 lists these codes.
35c. DATE. Enter ordinal date accepted (YYDDD).
35d. TIME. Enter the military time that the work was started.
36a. WORK STARTED BY. The person assigned the work enters employee number in this block.
36b. STATUS. Enter the completed work request status code. Table B–21 lists these codes.
36c. DATE. Enter the ordinal date the work was completed (YYDDD).
36d. TIME. Enter the military time that the inspection was completed.
37a. INSPECTED BY. The person clearing the work enters first initial and last name in this block. 37b. STATUS. Enter the work request
status code. Appendix B lists these codes.
37c. DATE. Enter the ordinal date the inspection was completed.
37d. TIME. Enter the military time that the inspection was completed (YYDDD).
38a. PICKED UP BY. The person picking up the equipment for the owner enters first initial and last name in this block.
38b. STATUS. The support maintenance clerk enters work request status code U (picked up). Table B–21 lists these codes.
38c. DATE. Enter the ordinal date the equipment was picked up (YYDDD).
38d. TIME. Enter the military time that the equipment was picked up.
Figure 3–42. Sample DA Form 2407 used for serial number tracking
114 DA PAM 750–8 22 August 2005