manual-tmm-xxxx-3-profi-heli-hp-v230 - MGM COMPRO Top
manual-tmm-xxxx-3-profi-heli-hp-v230 - MGM COMPRO Top
manual-tmm-xxxx-3-profi-heli-hp-v230 - MGM COMPRO Top
- TAGS
- compro
- mgm-compro.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Parameter A<br />
Parameter B<br />
. . . . .<br />
Parameter F<br />
controller time transmitter<br />
2× BEEP<br />
Controller<br />
ON<br />
(switch OFF)<br />
3× BEEP a 3×<br />
blink LED<br />
2× BEEP<br />
������<br />
1× BEEP ��<br />
2× BEEP<br />
����<br />
����<br />
BEEP<br />
LED<br />
1× BEEP ��<br />
3× BEEP ������<br />
1× BEEP ��<br />
����<br />
1× BEEP ��<br />
3× BEEP ������<br />
1× BEEP ��<br />
1× BEEP ��<br />
3× BEEP ������<br />
1× BEEP ��<br />
Flight mode<br />
switch to „0“<br />
Throttle to „max.“ position<br />
Transmitter ON<br />
wait10 sec.<br />
Max. 3 vt.<br />
No time limit<br />
PROGRAMMING MODE<br />
1× for value 1,<br />
2× for value 2, etc.<br />
1× for value1,<br />
2× for value 2, etc<br />
1× for value1,<br />
2× for value 2, etc.<br />
Throttle to „min.“ position<br />
up to 3 sec.<br />
Value setup<br />
Parameter B<br />
ENTER and<br />
going to programming parameter C<br />
etc. next<br />
parameters<br />
Value setup<br />
Parameter F<br />
ENTER and<br />
terminate programming<br />
(values of all parameters are saved)<br />
Controller off<br />
0<br />
Value setup:<br />
parameter A<br />
ENTER and<br />
going to parameter B<br />
8 / 8 HELI high power<br />
PROGRAMMING TMM <strong>xxxx</strong> – 3, HELI<br />
a) mode and parameter programming b) revolution programming (parameter A - 5)<br />
A=1 to4 A=5<br />
BEEP<br />
LED<br />
Legend:<br />
3× blink external LED<br />
Throttle to any position between –85<br />
a +100%, controller automatically<br />
start motor to 50% of max. rpm.<br />
After 5 sec. controller stopped motor<br />
automatically.<br />
You can stopped motor<br />
any time by throttle<br />
moving to zero position<br />
(-100%)<br />
Wait for stop on motor (and rotor)<br />
Controller off<br />
min. throttle max. throttle<br />
½ throttle<br />
set ½ throttle,<br />
after 2 beeps back to min. throttle<br />
set full throttle,<br />
after 3 beeps back to min. throttle<br />
(= ENTER)