For inspection purposes only. Consent of copyright owner required ...
For inspection purposes only. Consent of copyright owner required ... For inspection purposes only. Consent of copyright owner required ...
Datasheet: P1 Data GB01 Thermally Bonded Nonwovens Dated 01.01.2010 Page 1 of 2 Product Grades 700 900 1000 1300 1500 2000 3000 4000 4500 Mechanical Properties (Mean values) Tensile Strength EN ISO 10319 kN/m 6.0 7.5 8.0 10.5 12.5 14.5 18.0 22.0 30.0 Elongation EN ISO 10319 % 22 23 24 24 27 27 30 30 35 CBR Puncture Resistance EN ISO 12236 N 1050 1350 1500 2000 2250 2750 3250 4300 5350 Tensile at 5% Elongation EN ISO 10319 kN/m 2.6 3.2 3.4 4.3 4.7 5.5 6.3 7.5 9.0 Dynamic Cone Puncture EN ISO 13433 mm 42 40 38 34 32 26 24 22 14 Hydraulic Properties (Mean values) Permeability (H50) EN ISO 11058 l/m 2 .s (10 ‐3 m/s) 130 105 100 80 75 65 55 45 35 Opening Size (O90) EN ISO 12956 μm 180 160 150 130 125 110 100 85 75 Physical Properties (Typical values) Mass per Unit Area EN ISO 9864 g/m 2 90 115 120 155 175 210 250 330 400 Thickness EN ISO 9863‐1 mm 0.6 0.7 0.75 0.85 0.9 1.1 1.2 1.4 1.6 Roll Width m 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 4.5 Roll Length m 150 150 100 100 100 100 100 50 50 Roll Weight kg 65 85 60 75 85 100 120 80 95 The above listings refer to standard product weights and roll sizes. Other weights, sizes and colour maybe available on request. For further information please contact Terram Technical Support . The information contained herein is, to the best of our knowledge, accurate in all material respects. However, since the circumstances and condi‐ tions in which such information and the products mentioned herein can be used may vary and are beyond our control, no representation or war‐ ranty, express or implied, of any nature whatsoever is or will be made and no responsibility or liability is or will be accepted by us, any of our affili‐ ates or our or their respective directors, officers, employees or agents in relation to the accuracy or completeness or use of the information con‐ tained herein or any such products and any such liability is expressly disclaimed. FM22730 CPD 0338 For inspection purposes only. Consent of copyright owner required for any other use. EPA Export 24-08-2012:23:55:49
Datasheet: P1 Data GB01 Notes Composition and Environmental Behaviour Composition 70% polypropylene / 30% polyethylene. Durability The products are predicted to be durable for more than 25 years for non reinforcing applications, in soils with a range of pH 2‐14 and soil temperatures less than 25 degrees C. Chemical Resistance Alkali ‐ Resistant to all naturally occurring soil alkalis. Acid ‐ Resistant to all naturally occurring soil acids, (i.e. to acids of pH 2). Biological Resistance Terram is unaffected by bacteria, fungi, etc. Since it is not a source of nourishment, rats and termites will not eat the product as food. Reaction to Temperature The tensile strength of Terram decreases with increase in temperature, but recovers fully when the geotextile is re‐ turned to normal ambient temperature. Exposure to Sunlight Terram is delivered in polyethylene wrappers to protect it from the harmful effects of ultra‐violet rays: it is recom‐ mended that it remains wrapped until it is to be used. The unwrapped product shall be completely covered within 14 days after installation to avoid UV radiation exposure For projects where prolonged exposure is inevitable Terram grades with UV resistance to match the requirement are offered. In these grades the UV light resistance is enhanced by appropriate stabilisers in the polymers. Dated 01.01.2010 Page 2 of 2 All other properties are identical to the corresponding stan‐ dard series Terram presented in the data sheet. Terram prod‐ ucts with enhanced UV resistance carry the suffix UV (e.g. Terram 1000 UV). Notes 1. The stated properties are family mean values of the ap‐ propriate tests derived over periods of time. 2. The mean tensile values quoted are the mean values in either the length or cross directions, whichever is the lower. 3. For a full description of the test procedures quoted please refer to the specific methods of test. 4. Where widths or lengths greater than those supplied on one roll are required, jointing is normally effected by sim‐ ple overlapping. However, depending upon application, sub‐grade conditions, material loading, convenience and cost, alternative methods (pegging, sewing, stapling or gluing) may be used. Please refer to the Terram Jointing Methods leaflet for more details. 5. As part of its continual improvement process Terram Ltd reserve the right to change the properties listed on this data sheet without prior notice. For inspection purposes only. Consent of copyright owner required for any other use. The information contained herein is, to the best of our knowledge, accurate in all material respects. However, since the circumstances and condi‐ tions in which such information and the products mentioned herein can be used may vary and are beyond our control, no representation or war‐ ranty, express or implied, of any nature whatsoever is or will be made and no responsibility or liability is or will be accepted by us, any of our affili‐ ates or our or their respective directors, officers, employees or agents in relation to the accuracy or completeness or use of the information con‐ tained herein or any such products and any such liability is expressly disclaimed. EPA Export 24-08-2012:23:55:49
- Page 1 and 2: For inspection purposes only. Conse
- Page 3 and 4: Storage Systems Portasilo® M-Type
- Page 5 and 6: BRIDGEMONT BMS For inspection purpo
- Page 7 and 8: Weigh Bars ® Braided stainless ste
- Page 9 and 10: The newforce BridgeMont’s innovat
- Page 11 and 12: WESLEY Wheel Wash : Specification W
- Page 13: Pump House Fitted With • 24 volt
- Page 17 and 18: Datasheet: D1 Data GB05 Water Flow
- Page 19 and 20: Application Sheet system to avoid a
- Page 21 and 22: GSE STANDARD PRODUCTS GEOMEMBRANE Q
- Page 23 and 24: GSE HD GSE HD is a high quality, hi
- Page 25 and 26: system can be thoroughly electrical
- Page 27 and 28: Contents 3 Introduction 6 Factors a
- Page 29 and 30: Landfill cells of any shape and siz
- Page 31 and 32: Four (DAC) cores of approximately 9
- Page 33 and 34: Stability on Slopes 13 Key Points D
- Page 35 and 36: Robustness In terms of relative rob
- Page 37 and 38: Cost DAC has been used as an imperm
- Page 39 and 40: Walo UK Limited is a division of th
- Page 41 and 42: For inspection purposes only. Conse
- Page 43 and 44: SuDS Site Evaluation Site Name: MEH
- Page 45 and 46: The Use of SuDS for Infiltration Th
- Page 47 and 48: 100 Year incl. 10%CC 81 m³ Filter
- Page 49 and 50: Qbar (2.3 Year) 3,786 m³ Rainfall
- Page 51 and 52: Total PRELIMINARY - SURFACE WATER S
- Page 53 and 54: Pipe Run Area Imperm. Imperm. Area
- Page 55 and 56: POLLUTANT REMOVAL �Ideally sedime
- Page 57 and 58: For inspection purposes only. Conse
- Page 59 and 60: DETENTION BASINS S I T E CONTROL Vo
- Page 61 and 62: STORMWATER WETLANDS REGIONAL CONTRO
- Page 63 and 64: OIL INTERCEPTORS Example of an Oil
Datasheet: P1 Data GB01<br />
Notes<br />
Composition and Environmental<br />
Behaviour<br />
Composition<br />
70% polypropylene / 30% polyethylene.<br />
Durability<br />
The products are predicted to be durable for more than 25<br />
years for non reinforcing applications, in soils with a range <strong>of</strong><br />
pH 2‐14 and soil temperatures less than 25 degrees C.<br />
Chemical Resistance<br />
Alkali ‐ Resistant to all naturally occurring soil alkalis.<br />
Acid ‐ Resistant to all naturally occurring soil acids, (i.e. to<br />
acids <strong>of</strong> pH 2).<br />
Biological Resistance<br />
Terram is unaffected by bacteria, fungi, etc. Since it is not a<br />
source <strong>of</strong> nourishment, rats and termites will not eat the<br />
product as food.<br />
Reaction to Temperature<br />
The tensile strength <strong>of</strong> Terram decreases with increase in<br />
temperature, but recovers fully when the geotextile is re‐<br />
turned to normal ambient temperature.<br />
Exposure to Sunlight<br />
Terram is delivered in polyethylene wrappers to protect it<br />
from the harmful effects <strong>of</strong> ultra‐violet rays: it is recom‐<br />
mended that it remains wrapped until it is to be used.<br />
The unwrapped product shall be completely covered within<br />
14 days after installation to avoid UV radiation exposure<br />
<strong>For</strong> projects where prolonged exposure is inevitable Terram<br />
grades with UV resistance to match the requirement are<br />
<strong>of</strong>fered. In these grades the UV light resistance is enhanced<br />
by appropriate stabilisers in the polymers.<br />
Dated 01.01.2010 Page 2 <strong>of</strong> 2<br />
All other properties are identical to the corresponding stan‐<br />
dard series Terram presented in the data sheet. Terram prod‐<br />
ucts with enhanced UV resistance carry the suffix UV (e.g.<br />
Terram 1000 UV).<br />
Notes<br />
1. The stated properties are family mean values <strong>of</strong> the ap‐<br />
propriate tests derived over periods <strong>of</strong> time.<br />
2. The mean tensile values quoted are the mean values in<br />
either the length or cross directions, whichever is the<br />
lower.<br />
3. <strong>For</strong> a full description <strong>of</strong> the test procedures quoted please<br />
refer to the specific methods <strong>of</strong> test.<br />
4. Where widths or lengths greater than those supplied on<br />
one roll are <strong>required</strong>, jointing is normally effected by sim‐<br />
ple overlapping. However, depending upon application,<br />
sub‐grade conditions, material loading, convenience and<br />
cost, alternative methods (pegging, sewing, stapling or<br />
gluing) may be used. Please refer to the Terram Jointing<br />
Methods leaflet for more details.<br />
5. As part <strong>of</strong> its continual improvement process Terram Ltd<br />
reserve the right to change the properties listed on this<br />
data sheet without prior notice.<br />
<strong>For</strong> <strong>inspection</strong> <strong>purposes</strong> <strong>only</strong>.<br />
<strong>Consent</strong> <strong>of</strong> <strong>copyright</strong> <strong>owner</strong> <strong>required</strong> for any other use.<br />
The information contained herein is, to the best <strong>of</strong> our knowledge, accurate in all material respects. However, since the circumstances and condi‐<br />
tions in which such information and the products mentioned herein can be used may vary and are beyond our control, no representation or war‐<br />
ranty, express or implied, <strong>of</strong> any nature whatsoever is or will be made and no responsibility or liability is or will be accepted by us, any <strong>of</strong> our affili‐<br />
ates or our or their respective directors, <strong>of</strong>ficers, employees or agents in relation to the accuracy or completeness or use <strong>of</strong> the information con‐<br />
tained herein or any such products and any such liability is expressly disclaimed.<br />
EPA Export 24-08-2012:23:55:49