Product Selection CHARTS - Parchem

joint filler Product Selection
Application Solution
Joint Filler Boards &
Joint Backing Rods
Low load transfer, joint filler, for brickwork,
blockwork, and pedestrian traffic concrete
expansion & isolation joints
Semi-rigid, joint filler, for forming expansion
joints in concrete, brickwork, blockwork and
water retaining / excluding structures
Medium load rigid, non-expanding joint
filler, for internal & external traffic areas,
roads, concrete slabs and pavements
High load rigid, self-expanding joint filler, for
internal & external traffic areas, roads, bridges,
carparks, water retaining / excluding structures
High load rigid, self-expanding joint filler & sealer,
for internal & external traffic areas, roads, bridges,
carparks, water retaining / excluding structures
Low load, medium density, closed cell,
polyethylene backing rod range
Low density, open cell, polyurethane
backing rod range
Compressible, bitumen impregnated fibre
board filler, for pavements, floors, roads
Polystyrene isolation joint, blockouts, bolt
sleeves, cylinders, etc., filler material
Polyethylene tape used to isolate sealants
from substrates or joint fillers, to prevent
three sided adhesion
Cut to size from sheet or
rolls
Cut to size from sheet,
fixed or bonded to
substrate
Rolls, Rod, cut to length,
friction inserted
Cut to size from sheet,
fixed or bonded to
substrate
Roll width selected, cut to
length, hand applied
Compressible polyethylene, closed cell, nonabsorbent,
rot-proof, joint filler
Non absorbent, closed cell, polyethylene joint filler,
non-tainting, rot proof, RTA T1204 compliant
Resilient and waterproof, economical, ASTM Spec.
D1752-84 (Type 111)
Resilient and waterproof, expands to fill joint, ASTM Spec.
D1752-84 (Type 111), US Fed Spec. HH-F-34F (Type 11,
Class C)
Resilient and waterproof, expands to fill joint will not
extrude under pressure, ASTM Spec. D1752-84 (Type
111), Dept. Housing & Const. Spec. RA SS 106
Acts as both a bond breaker and joint profile former to
support all elastomeric sealants, between all common
building materials
Jointflex
Stiffjoint
Hydrocor Type 2
Hydrocor Type 3
Hydrocor Type 106
Expandafoam
Flexible, versatile, backing rod Emer-Seal Backing Rod
Resilient, will not extrude under pressure. Only
suitable for bitumen based sealants
Cellflex
Economical, lightweight, versatile, compressible filler Polystyrene
Economical, 66m tape rolls, in 12mm; 15mm; 20mm;
25mm; & 50mm widths
Bond Breaker Tape