CATERPILLAR

More documents

Recommendations

Info

Labor Upload - Daily Process Illustration 34: Open the SIMS/DBS Upload Utility. Select file in the upper left corner and then select Upload Settings. Illustration 35: 54
Select the Upload Settings Tab and then place a check in the Upload Labor and Travel Times. Un-check all other upload categories. Select Save to save the settings. Illustration 36: Select the labor template and select View Report. 55
Page 1 and 2:
1 CATERPILLAR Service Technician Wo
Page 3 and 4: Table of Contents Introduction.....
Page 5 and 6: Installation.......................
Page 7 and 8: Computer/Software Hardware Recommen
Page 9 and 10: If you do not have Service Technici
Page 11 and 12: Illustration 4: The STW setup will
Page 13 and 14: Select the “Yes” button to cont
Page 15 and 16: Step 8 Select Components The Select
Page 17 and 18: Frequently Asked Questions If you a
Page 19 and 20: Q) How do I subscribe to SIS and/or
Page 21 and 22: Purpose If communicating Service In
Page 23 and 24: - OR - 7X-1700 - Caterpillar Commun
Page 25 and 26: Instructions To set up the Communic
Page 27 and 28: The service tool will remain unaffe
Page 29 and 30: 202 A required INI file was not loc
Page 31 and 32: Challenger Technician Purpose The C
Page 33 and 34: Dataview DataView measures and logs
Page 35 and 36: • To Delete Existing Lines from a
Page 37 and 38: MNTWOCTL (Direct Labor to Approval
Page 39 and 40: Illustration 14: Enter the intended
Page 41 and 42: Illustration 16: A question mark ca
Page 43 and 44: Illustration 19: Other shift time e
Page 45 and 46: Illustration 22: Enter the appropri
Page 47 and 48: Labor Approval Setup - DBS DBS must
Page 49 and 50: Labor Upload -End of Job Setup Illu
Page 51 and 52: Illustration 29: Open the SIMS DBS
Page 53: Illustration 32: Save the report te
Page 57 and 58: Example of file name and save: AA00
Page 59 and 60: 1-877-598-8920 DCS Support Center:
Page 61 and 62: 1. Run the SIS Setup CD on the netw
Page 63 and 64: o Select the TA inspection to open.
Page 65 and 66: � � Illustration 43: TA Search
Page 67 and 68: o o Illustration 46: The TA Navigat
Page 69 and 70: o Following are items and their bac
Page 71 and 72: Step 9 On the STW installation main
Page 73 and 74: Step 12 In the Software License Agr
Page 75 and 76: Step 15 After the files have been c
Page 77 and 78: Illustration 57: Program Maintenanc
Page 79 and 80: Step 17 After the files have been c
Page 81 and 82: Illustration 63: Monthly Data Updat
Page 83 and 84: Service Information System Web (SIS
Page 85 and 86: Parts Integrator Purpose Parts Inte
Page 87 and 88: - The integration software has been
Page 89 and 90: Illustration 74: Step 8 Once the
Page 91: Refer to the STW Knowledge Entry li
show all

CATERPILLAR

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?