Catalytic Synthesis and Characterization of Biodegradable ...

More documents

Recommendations

Info

Chapter 1 synthesized hyaluronic acid (HA)-doped PPy and explored its tissue engineering applications. 129 In vivo studies showed that the introducing of HA into PPy films improved the biocompatibility of PPy and promoted the vascularization. It should be noted that both conductivity and the film surface are often greatly changed when biologically active molecules are used as dopants. 129, 130 For example, the morphology and conductivity of polypyrrole-based films with different dopants were systematically studied. It was concluded that larger biomolecule dopants can significantly decrease conductivity and affect more obviously on morphology compared to small dopants. However, the exact effects of particular dopants are not very predictable (Figure 1.5.5). Figure 1.5.5 Morphology of thick PPy films as assessed using scanning electron microscopy (SEM) (top) and corresponding cyclic voltammograms (CVs), indicating electrical activity of the materials (bottom). (A) PPyCl. (B) PPy doped with poly(vinyl sulfate). (C) PPy doped with dermatan sulfate. (D) PPy doped with collagen (inset: thin film of collagen-doped PPy). A narrow ‐ 24 ‐
- 25 - Polymerization and Applications of Biodegradable Polyesters CV spectrum correlates to decreased electroactivity. Scale bars are 100 μm. 130 PPy can not be further covalently modified due to there are no functional pendent or terminal groups on its chain. This limitation can be overcome by doping with polymers having functional groups. A good example of this technique is conducted by Song et al. In their report, PPy was doped with poly(glutamic acid) (PGlu), which has pendent carboxylic acid groups could further react with amino of polylysine and/or laminin. Dorsal root ganglion (DRG) neurons were observed to preferentially adhere to and extend neurites on the PPy surfaces modified with polylysine and/or laminin (Figure 1.5.6). 130 Figure 1.5.6 Phase contrast and fluorescence images of DRGs adhered to the surface of pPy-X, where X = 1. pLys, 2. Lmn, and 3. pLys-Lmn. Cell nuclei were labeled with DAPI (blue florescence). All images were taken at 10× magnification and the 200 μm scale bar applies to all images shown. 130 PPy is not biodegradable in nature and many works were carried out to blend it with biodegradable polymeric materials to obtain partially absorbable materials. For example, PPy nanoparticle was blended with PLA to fabricate a composite which is both biodegradable and conductive. 117 Altering the content of PPy in the composites will result in the changes of both
Page 1 and 2: Catalytic Synthesis and Characteriz
Page 3 and 4: Preface Biodegradable polyesters ha
Page 5 and 6: Chapter 3 Polymerization of Lactic
Page 7 and 8: Chapter 1 Polymerization and Applic
Page 9 and 10: - 3 - Polymerization and Applicatio
Page 13 and 14: 1.2.2 Aluminum Catalysts - 7 - Poly
Page 17 and 18: 1.3 Polylactide 1.3.1 Introduction
Page 19 and 20: - 13 - Polymerization and Applicati
Page 21 and 22: 1.3.4 Application of PLA Figure 1.3
Page 27 and 28: 1.5.1.4 Polyaniline (PANi) - 21 - P
Page 29: - 23 - Polymerization and Applicati
Page 47 and 48: 1.6.1 Radical Polymers for Organic
Page 51 and 52: initialization of the device by app
Page 55 and 56: 1.6.2.4 Others - 49 - Polymerizatio
Page 63 and 64: 182. R. B. Weller, J. Invest. Derma
Page 65 and 66: Chapter 2 Synthesis and Electrochem
Page 67 and 68: Synthesis and Electrochemistry of S
Page 79: Synthesis and Electrochemistry of S
Page 84 and 85:
Chapter 3 3.1 Introduction Poly(lac
Page 86 and 87:
Chapter 3 polydispersity index (PDI
Page 88 and 89:
Chapter 3 aluminum based complexes
Page 90 and 91:
Chapter 3 3.5 Conclusions Co(III) c
Page 92 and 93:
Chapter 3 22. Z. H. Tang, X. S. Che
Page 94 and 95:
Chapter 4 4.1 Introduction Stimulus
Page 96 and 97:
Chapter 4 the proton of methenyl gr
Page 98 and 99:
Chapter 4 attributed to the amide g
Page 100 and 101:
Chapter 4 4.4 Thermal Properties Th
Page 102 and 103:
Chapter 4 Figure 4.8 MTT assay for
Page 104 and 105:
Chapter 4 The 1 H NMR and 13 C NMR
Page 106 and 107:
Chapter 4 Cell viability (%) = (Asa
Page 109 and 110:
Chapter 5 Synthesis of Triblock Cop
Page 111 and 112:
5.2 Synthesis of Triblock Copolymer
Page 113 and 114:
Sample Table 1. Feed and result com
Page 115 and 116:
= 25 μm. B: MTT assay for the cyto
Page 117 and 118:
‐ 109 ‐ Synthesis of Triblock C
Page 119:
‐ 111 ‐ Synthesis of Triblock C
Page 124 and 125:
Chapter 6 6.1 Introduction Since th
Page 126 and 127:
Chapter 6 6.3 Synthesis of MPEG-b-P
Page 128 and 129:
Chapter 6 used to characterize the
Page 130 and 131:
Chapter 6 Figure 6.6 Cyclic voltamm
Page 132 and 133:
Chapter 6 vivo cytotoxicity was als
Page 134 and 135:
Chapter 6 NMR. Characterization of
Page 136 and 137:
Chapter 6 CO2 for 24 h. RSC96 cells
Page 141 and 142:
Chapter 7 Conclusion and Future Pro
Page 143 and 144:
‐ 131 ‐ Conclusion and Future P
Page 145 and 146:
‐ 133 ‐ Conclusion and Future P
Page 147 and 148:
13. Xuan Pang, Xuesi Chen, Xiuli Zh
Page 149:
Acknowledgments The present thesis
show all

Catalytic Synthesis and Characterization of Biodegradable ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?