SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Switching On and Off SMA Solar Technology AG<br />
9 Switching On and Off<br />
9.1 Switching On<br />
1. Check the following requirements:<br />
– correct electrical connections<br />
– voltages and polarities<br />
2. Switch the <strong>Sun</strong>ny Island DC circuit breaker to the "ON" position.<br />
☑ The display light of the <strong>Sun</strong>ny Island switches on.<br />
☑ The <strong>Sun</strong>ny Island initiates the start-up phase. The<br />
notifications shown here are displayed. The last<br />
notification is displayed as soon as the start-up<br />
phase is completed.<br />
3. Start QCG (press and hold down until the <strong>Sun</strong>ny Island beeps three times).<br />
☑ The QCG is started and the notification<br />
displayed here is shown. Continue as described<br />
in section 8.2 ”Starting the Quick Configuration<br />
Guide (QCG)” (page 57).<br />
or<br />
Systems with several <strong>Sun</strong>ny Islands<br />
Switch on the Slaves before you switch on the master. To do this, proceed as follows.<br />
"250.01 AutoStr" Parameter<br />
Even with the "250.01 AutoStr" parameter set, the <strong>Sun</strong>ny Island must be manually started<br />
after each time the device is switched on using the DC circuit breaker.<br />
����������������<br />
������<br />
���������<br />
������������<br />
������������<br />
62 SI<strong>5048</strong>-TB-TEN110340 <strong>Technical</strong> <strong>Description</strong>