SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Initial Start-up SMA Solar Technology AG<br />
8.3 Commissioning the Battery Current Sensor<br />
In the event you have installed a battery current sensor in your system, you are required to synchronize<br />
the device's internal offset. To do this, proceed as follows:<br />
1. Switch the <strong>Sun</strong>ny Island to standby as described in section 9.2 ”Stopping the <strong>Sun</strong>ny Island<br />
(Standby)” (page 63).<br />
NOTICE!<br />
System error due to wrong parameters being entered.<br />
All parameter settings which could affect the operating safety of the stand-alone system are<br />
protected by the installer password.<br />
• Only electrically skilled persons are permitted to set and adjust system parameters.<br />
• Enter the password as described in section 10.5 ”Entering the Installer Password”<br />
(page 76).<br />
2. Short-circuit the battery current sensor cables.<br />
– BatCur+ to terminal 1<br />
– BatCur − to terminal 1<br />
3. Set the following parameters:<br />
Choose the type of battery current sensor:<br />
– "225.01 BatCurSnsTyp" (None / 50 mV / 60 mV). Only after activation of the parameter<br />
with 50 mV or 60 mV other parameters (02, 03 and 04 in the menu "225# Battery Current<br />
Sensor") will be shown and activated.<br />
4. Set the nominal current for the battery current sensor (e.g., 400 A / 60 mV):<br />
– "225.02 BatCurGain60" (for a 60 mV output)<br />
– "225.03 BatCurGain50" (for a 50 mV output)<br />
5. Start automatic calibration:<br />
– Set "225.04 BatCurAutoCal" to "Start".<br />
☑ The <strong>Sun</strong>ny Island conducts an automatic calibration.<br />
6. Check the offset error:<br />
Display value "120.06 TotBatCur" should be (close to) zero.<br />
60 SI<strong>5048</strong>-TB-TEN110340 <strong>Technical</strong> <strong>Description</strong>