SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
SUNNY ISLAND 5048 - Technical Description - Wind & Sun Ltd.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Troubleshooting SMA Solar Technology AG<br />
20 Troubleshooting<br />
In general the <strong>Sun</strong>ny Island distinguishes between events and errors.<br />
• Events describe state changes or transient states (e.g. generator connection).<br />
• Errors describe states that are not permitted or are only permitted up to a certain rate.<br />
This includes warnings, failures and errors. A user interaction is generally required.<br />
20.1 Failure Acknowledgement<br />
If there is a failure or an error, the <strong>Sun</strong>ny Island goes into standby.<br />
Proceed as follows to confirm a failure:<br />
1. Remove the cause.<br />
2. Confirm error with .<br />
3. Start the <strong>Sun</strong>ny Island again.<br />
20.2 Autostart Handling<br />
The <strong>Sun</strong>ny Island has an autostart meter which counts down by 1 with every automatic start. After<br />
10 minutes of normal operation of the <strong>Sun</strong>ny Island, the autostart meter is set back to its original value.<br />
If another fault occurs when the autostart meter is at 0, the <strong>Sun</strong>ny Island waits for 10 minutes and then<br />
attempts to restart. The autostart meter begins to run again.<br />
The number of the autostarts allowed can be set using the "250.01 AutoStr" parameter (in standby<br />
mode).<br />
194 SI<strong>5048</strong>-TB-TEN110340 <strong>Technical</strong> <strong>Description</strong>
Change language