Sensor systems 2 AS-Interface
Sensor systems 2 AS-Interface Sensor systems 2 AS-Interface
VBG-PB-K5-R4-DMD Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories AS-Interface gateway Order code Features 36 U® 62 Spec 2.1 VBG-PB-K5-R4-DMD PROFIBUS gateway, double master for 2 AS-Interface networks Gateway according to AS-Interface specifikation 2.1 for up to 62 units Connection to PROFIBUS DP 2 AS-Interface networks Acyclic communication in accordance with PROFIBUS DP V1 Commissioning, without PROFIBUS communication All AS-Interface functions can be called via PROFIBUS Fault diagnosis via LEDs and grafic display Easy commissioning, by grafic display AS-Interface monitor or extended AS- Interface diagnostic read via display Dimensions 100 Electrical connection + - + - Plug-in jumpers Pos. 1 Pos. 2 + - + - Indicating/operating means POWER PROFIBUS CONFIG ERR U AS-i AS-i ACTIVE PRG ENABLE PRJ MODE VBG-PB-K5-R4-DMD Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com 110 AS-Interface 1 AS-Interface 2 a 24 V 0 V b + - – Using plug-in jumpers, it is possible to choose whether the master shall be supplied by AS-Interface-1 circuit (pos.1) or via an own power pade (PELV) (pos. 2). MODE / OK ESC SET / AS-i 1 AS-i 2 PWR CONFIG + - + - + - + - a 24V 0V b µP – . 3 8 VBG-PB-K5-R4-DMD 75 Sub-D socket RxD/TxD-P RxD/TxD-N Screen PROFIBUS Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005
Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005 AS-Interface gateway Technical data General specifications AS-Interface specification Indicators/operating means V2.11 LC display, two-digit address display, error message LED BUS ACTIVE PROFIBUS master detected; LED green LED AS-i ACTIVE AS-Interface operation normal; LED green LED CONFIG ERR configuration error; LED red LED PRG ENABLE autom. programming; LED green LED ENERGY voltage ON; LED green LED PRJ MODE projecting mode active; LED yellow LED U AS-i AS-Interface voltage; LED green Switch SET Selection and setting of a slave address OK button Mode selection traditional-graphical/confirmation Button MODE Mode selection PRJ-operation/save configuration/cursor ESC button Electrical specifications Mode selection traditional-graphical/cancel Insulation voltage Ui ≥ 500 V Rated operational voltage Ue from AS-Interface Rated operational current Ie ≤ 180 mA from AS-Interface Interface Protocol PROFIBUS Interface type RS 485 Transfer rate Connection 9.6; 19.2; 44.44; 93.95; 187.5; 500; 1500 kBit/s self-synchronising PROFIBUS RS 485 interface AS-Interface Ambient conditions screw terminals Ambient temperature 0 ... 55 °C (273 ... 328 K) Storage temperature Mechanical specifications -15 ... 75 °C (258 ... 348 K) Protection degree Housing: IP40 according to DIN 40050 terminals: IP20 according to DIN 40050 Mass 420 g Construction type terminal rail housing, LDG-A-30 Software The device is supplied with the configuration data files (GSD) as well as a restricted version of the AS-i Control Tools software. The software performs the addressing, programming and monitoring of the AS-Interface network. The full version of the AS-i Control Tool is available as an accessory and features an expanded diagnostics monitor as well as a larger program memory for AS-Interface Control which makes it possible to detect faulty telegrams of slaves. A GSD file can be easily created for the PROFIBUS DP using the GSD assistant, whereby the size of the I/O windows can be conveniently adapted to the AS-Interface circuit's load and the AS-Interface configuration can be stored within the GSD file. A text file is also created, which documents the status of AS-Interface data in the gateway's I/O window. Note: The VAZ-PB-SIM accessory is required for the AS-i Control Tool. Function VBG-PB-K5-R4-DMD The VBG-PB-K5-R4-DMD is a PROFIBUS gateway with 2 AS-Interface masters in accordance with AS-Interface specification 2.11 in IP20. The design is especially suitable for use in the switch cabinet. The VBG-PB-K5-R4-DMD is a modular PROFIBUS slave. This means that the user can use the PROFIBUS configuration tool to specify what data will be transferred via the PROFIBUS. This makes it possible to adjust the amount of data to be transferred via PROFIBUS. In addition, this gateway supports acyclical communication of the PROFIBUS DP V1. These acyclical services can be used to access a mailbox in the gateway that provide access to all the data that are made available by the AS-Interface/PROFIBUS gateway. A push button can be used to accept the target configuration and to adjust the PROFI- BUS address and baud rate. There are 7 LEDs on the front panel, showing the current status of the AS-Interface line. In the case of the AS-Interface gateway with graphical display, the AS-Interface circuit can be placed in service and the test of the connected periphery can be kept entirely separate from the commissioning of the PROFIBUS and the programming. On-site operation with the aid of the graphical display and 4 push buttons makes it possible to show all functions on the display that are covered by the AS-i Control Tools software for other AS-Interface masters. Accessories VAZ-SW-ACT32 Full version of the AS-i Control Tools VAZ-PB-SIM PROFIBUS master simulator Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com 37 Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories
- Page 1 and 2: FACTORY AUTOMATION Sensor systems 2
- Page 3 and 4: Issue date 2004-11-19 - Catalogue A
- Page 5 and 6: Issue date 2004-11-19 - Catalogue A
- Page 7 and 8: Issue date 2004-11-19 - Catalogue A
- Page 9 and 10: Issue date 2004-11-19 - Catalogue A
- Page 11 and 12: Issue date 2004-11-19 - Catalogue A
- Page 13 and 14: Issue date 2004-11-19 - Catalogue A
- Page 15 and 16: Issue date 2004-11-19 - Catalogue A
- Page 17 and 18: Issue date 2004-11-19 - Catalogue A
- Page 19 and 20: Issue date 2004-11-19 - Catalogue A
- Page 21 and 22: Issue date 2004-11-19 - Catalogue A
- Page 23 and 24: Issue date 2004-11-19 - Catalogue A
- Page 25 and 26: Issue date 2004-11-19 - Catalogue A
- Page 27 and 28: Issue date 2004-11-19 - Catalogue A
- Page 29 and 30: Issue date 2004-11-19 - Catalogue A
- Page 31: Issue date 2004-11-19 - Catalogue A
- Page 35 and 36: Issue date 2004-11-19 - Catalogue A
- Page 37 and 38: Issue date 2004-11-19 - Catalogue A
- Page 39 and 40: Issue date 2004-11-19 - Catalogue A
- Page 41 and 42: Issue date 2004-11-19 - Catalogue A
- Page 43 and 44: Issue date 2004-11-19 - Catalogue A
- Page 45 and 46: Issue date 2004-11-19 - Catalogue A
- Page 47 and 48: Issue date 2004-11-19 - Catalogue A
- Page 49 and 50: Issue date 2004-11-19 - Catalogue A
- Page 51 and 52: Issue date 2004-11-19 - Catalogue A
- Page 53 and 54: Issue date 2004-11-19 - Catalogue A
- Page 55 and 56: Issue date 2004-11-19 - Catalogue A
- Page 57 and 58: Issue date 2004-11-19 - Catalogue A
- Page 59 and 60: Issue date 2004-11-19 - Catalogue A
- Page 61 and 62: Issue date 2004-11-19 - Catalogue A
- Page 63 and 64: Issue date 2004-11-19 - Catalogue A
- Page 65 and 66: Issue date 2004-11-19 - Catalogue A
- Page 67 and 68: Issue date 2004-11-19 - Catalogue A
- Page 69 and 70: Issue date 2004-11-19 - Catalogue A
- Page 71 and 72: Issue date 2004-11-19 - Catalogue A
- Page 73 and 74: Issue date 2004-11-19 - Catalogue A
- Page 75 and 76: Issue date 2004-11-19 - Catalogue A
- Page 77 and 78: Issue date 2004-11-19 - Catalogue A
- Page 79 and 80: Issue date 2004-11-19 - Catalogue A
- Page 81 and 82: Issue date 2004-11-19 - Catalogue A
VBG-PB-K5-R4-DMD<br />
Masters and<br />
Gateways<br />
Power Supplies,<br />
Extender, Repeaters<br />
Safety at work<br />
I/O Modules<br />
Control cabinet<br />
I/O Modules<br />
Field application<br />
Analogue modules<br />
Other modules<br />
Inductive sensors<br />
Photoelectric<br />
sensors<br />
Rotary encoders<br />
Accessories<br />
<strong>AS</strong>-<strong>Interface</strong> gateway<br />
Order code<br />
Features<br />
36<br />
U®<br />
62<br />
Spec 2.1<br />
VBG-PB-K5-R4-DMD<br />
PROFIBUS gateway, double master for<br />
2 <strong>AS</strong>-<strong>Interface</strong> networks<br />
Gateway according to <strong>AS</strong>-<strong>Interface</strong><br />
specifikation 2.1 for up to 62 units<br />
Connection to PROFIBUS DP<br />
2 <strong>AS</strong>-<strong>Interface</strong> networks<br />
Acyclic communication in accordance<br />
with PROFIBUS DP V1<br />
Commissioning, without PROFIBUS<br />
communication<br />
All <strong>AS</strong>-<strong>Interface</strong> functions can be<br />
called via PROFIBUS<br />
Fault diagnosis via LEDs and grafic<br />
display<br />
Easy commissioning, by grafic<br />
display<br />
<strong>AS</strong>-<strong>Interface</strong> monitor or extended <strong>AS</strong>-<br />
<strong>Interface</strong> diagnostic read via display<br />
Dimensions<br />
100<br />
Electrical connection<br />
+<br />
-<br />
+<br />
-<br />
Plug-in jumpers<br />
Pos. 1<br />
Pos. 2<br />
+<br />
-<br />
+<br />
-<br />
Indicating/operating means<br />
POWER<br />
PROFIBUS<br />
CONFIG ERR<br />
U <strong>AS</strong>-i<br />
<strong>AS</strong>-i ACTIVE<br />
PRG ENABLE<br />
PRJ MODE<br />
VBG-PB-K5-R4-DMD<br />
Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany<br />
Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com<br />
110<br />
<strong>AS</strong>-<strong>Interface</strong> 1<br />
<strong>AS</strong>-<strong>Interface</strong> 2<br />
a<br />
24 V<br />
0 V<br />
b<br />
+<br />
-<br />
–<br />
Using plug-in jumpers, it is possible to choose whether<br />
the master shall be supplied by <strong>AS</strong>-<strong>Interface</strong>-1 circuit<br />
(pos.1) or via an own power pade (PELV) (pos. 2).<br />
MODE /<br />
OK<br />
ESC<br />
SET /<br />
<strong>AS</strong>-i 1<br />
<strong>AS</strong>-i 2 PWR CONFIG<br />
+ - + - + - + -<br />
a 24V 0V b<br />
µP<br />
–<br />
.<br />
3<br />
8<br />
VBG-PB-K5-R4-DMD<br />
75<br />
Sub-D socket<br />
RxD/TxD-P<br />
RxD/TxD-N<br />
Screen<br />
PROFIBUS<br />
Issue date 2004-11-19 - Catalogue <strong>AS</strong>-<strong>Interface</strong> 2004/2005
Change language