Sensor systems 2 AS-Interface

Recommendations

Info

VBM-CTR-KF-R2 Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories AS-Interface master Order code Features 26 Stand-alone master with PLC functionality 62 Spec 2.1 VBM-CTR-KF-R2 AS-Interface master RS 232 cabinet module Two-digit LC display Voltage supply from AS-Interface Automatic baud rate detection Programmable slave addresses Display of detected slaves Fault diagnosis Parameterisation and monitor software Power Rail connection RS 232 interface Dimensions 60 Electrical connection AS-Interface - AS-Interface + AS-Interface - AS-Interface + AS-Interface - AS-Interface + Power Rail 4 5 24 23 33 32 5 4 Indicating/operating means POWER SER ACTIVE CONFIG ERR U ASI ASI ACTIVE PRG ENABLE PRJ MODE Terminal for wall mounting RS 232 VBM-CTR-KF-R2 Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com MODE SET 114 RS 232 3 2 5 25 26 27 35 36 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 Sub-D socket RxD TxD GND RxD TxD GND Screen 107 93 Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005
Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005 AS-Interface master Technical data General specifications AS-Interface specification Indicators/operating means V2.11 LC display, two-digit address display, error message LED AS-i ACTIVE AS-Interface operation normal; LED green LED CONFIG ERR configuration error; LED red LED PRG ENABLE autom. programming; LED green LED ENERGY voltage ON; LED green LED PRJ MODE projecting mode active; LED yellow LED SER ACTIVE interface in operation; LED green LED U AS-i AS-Interface voltage; LED green Switch SET Selection and setting of a slave address Button MODE Electrical specifications Mode selection/save configuration Insulation voltage Ui ≥ 500 V Rated operational voltage Ue from AS-Interface Rated operational current Ie ≤ 150 mA Interface Interface type RS 232 Transfer rate 1200 , 2400 , 4800 , 9600 , 19200 , 38400 or 57600 Bit/s , Automatic baud rate detection Cable length Connection max. 30 m AS-Interface Standard conformity removable coded terminals, Power Rail Electromagnetic compatibility IEC 62026-2, EN 61326 Fieldbus standard Ambient conditions IEC 62026-2 Ambient temperature 0 ... 55 °C (273 ... 328 K) Storage temperature Mechanical specifications -25 ... 70 °C (248 ... 343 K) Protection degree IP20 according to EN 60529 Mass 420 g Software The AS-i Control Tools software is supplied as restricted version together with the documentation. The software performs addressing, programming and monitoring of the AS-Interface network. In addition, it contains an editor that creates programs for the integrated PLC functionality. The full version of the AS-i Control Tool is available as an accessory and features an expanded diagnostics monitor as well as a larger program memory for AS-Interface Control which makes it possible to detect faulty telegrams of slaves. Function VBM-CTR-KF-R2 The VBM-CTR-KF-R2 is a stand-alone master with integrated PLC functionality. The design of this master is ideal for use in a cabinet. Its housing, only 60 mm wide, occupies little space in a cabinet installation. The VBM-CTR-KF-R2 is installed by snapping it onto the 35 mm DIN Rail per EN 50022, with the integrated Power Rail. The AS-Interface signal is transmitted through conductors, which are integrated into the Power Rail. Thus all cabinet modules in KF housing can be connected to the AS-Interface cable by simply snapping them onto the DIN Rail. Removable terminals for leading the AS- Interface cable through the cabinet are available. These terminals are coded and allow "online" maintenance, i. e. while the system is under power. The connection to the AS- Interface power supply is established through these terminals which can also be used for the serial interface. A 9-pin Sub-D connector is also available. Power to the master is supplied by the AS-Interface cable. Two push buttons are used for address assignment of the AS-Interface slaves and acceptance of the desired configuration. In configuration mode, all detected AS-Interface slaves are displayed on the 2-digit LCD. In normal operation, the LCD is blank unless the master detects a faulty AS-Interface slave. There are 7 LEDs on the front panel, showing the current status of the AS-Interface line. PLC functionality The VBM-CTR-KF-R2 provides 16 kB of program memory (approx. 2500 single binary commands), 8 kB of data memory, 1024 counters and 1024 timers for PLC functionality. These capacities suffice to process data on the AS-Interface. Thus the master can also be operated in "stand-alone" mode. The program processing time is approximately 1000 word commands every 2 ms. The programming language is based upon the STEP5 ® programming language. Accessories VAZ-SW-ACT32 Full version of the AS-i Control Tools UPR-05 Universal Power Rail with DIN rail and cover, 5 leads UPR-E End cap for UPR-03 und UPR-05 Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com 27 Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories
Page 1 and 2: FACTORY AUTOMATION Sensor systems 2
Page 3 and 4: Issue date 2004-11-19 - Catalogue A
Page 21: Issue date 2004-11-19 - Catalogue A
Page 73 and 74:
Issue date 2004-11-19 - Catalogue A
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
VAZ-PB-SIM Issue date 2004-11-19 -
Page 309 and 310:
VAZ-R4-R2 Issue date 2004-11-19 - C
Page 311 and 312:
U-G1FA Issue date 2004-11-19 - Cata
Page 313 and 314:
U-G1FFA Issue date 2004-11-19 - Cat
Page 315 and 316:
U-G1PP Issue date 2004-11-19 - Cata
Page 317 and 318:
U-G3FF Issue date 2004-11-19 - Cata
Page 319 and 320:
VAZ-T1-FK-1M-PUR-V1-W Issue date 20
Page 321 and 322:
VAZ-T1-G2F Issue date 2004-11-19 -
Page 323 and 324:
VAZ-T1-FK-M20 Issue date 2004-11-19
Page 325 and 326:
VAZ-V1-B Issue date 2004-11-19 - Ca
Page 327 and 328:
VAZ-TERM Issue date 2004-11-19 - Ca
Page 329 and 330:
Page 331 and 332:
UPR-05 Issue date 2004-11-19 - Cata
Page 333 and 334:
Page 335 and 336:
Page 337 and 338:
Page 339 and 340:
Page 341 and 342:
Page 343 and 344:
Page 345 and 346:
Page 347 and 348:
Page 349 and 350:
Date of issue 2004-19-11 - Catalogu
Page 351 and 352:
Page 353 and 354:
Page 355 and 356:
show all

Sensor systems 2 AS-Interface

Create successful ePaper yourself

Delete template?

Save as template?