Sensor systems 2 AS-Interface

Recommendations

Info

VBA-8E-G2-ZA Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories AS-Interface sensor module Features AS-Interface certificate Protection degree IP67 Does require two addresses Double A/B slave with extended addressing possibility for up to 62 slaves Double addressing jack Flat cable connection with cable piercing technique, variable flat cable guide Communication monitoring Inputs for 2-, 3-, and 4-wire sensors Supply for inputs from AS-Interface Ground connection (FE) possible Function display for bus and inputs Detection of overload on sensor supply 156 U ® LISTED 57M3 IND. CONT. EQ. CLASS 2 CIRCUIT ONLY Order code VBA-8E-G2-ZA G2 flat module 8 inputs (PNP) Dimensions 18.7 60 36 Electrical connection 1 2 ADDR ADDR 4 73.5 34.5 PWR/ FAULT PWR/ FAULT Indicating/operating means 1 4 1 AS-Interface + AS-Interface - AS-Interface + AS-Interface - 5 2 VBA-8E-G2-ZA Base is sold separately Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com sensor + sensor - sensor + sensor - sensor + sensor - sensor + sensor - 3 4 5 2 1 IN1.2 3 4 5 2 1 IN1.4 150 3 4 5 2 1 IN2.2 1 2 4 3 5 1 2 4 3 5 1 2 4 3 5 1 2 4 3 5 3 4 5 2 1 IN2.4 3 2 IN1.1 4 1 5 3 2 IN1.3 4 1 5 3 2 IN2.1 4 1 5 3 2 IN2.3 IN1.1 IN1.3 IN+ IN+ IN2 IN4 IN1 IN3 IN- IN- FG FG IN1.2 IN1.4 IN+ IN+ (nc) (nc) IN2 IN4 IN- IN- FG FG for 3-wire sensors for 3-wire sensors IN2.1 IN2.3 IN+ IN+ IN2 IN4 IN1 IN3 IN- IN- FG FG for 3-wire sensors IN2.2 IN2.4 IN+ IN+ (nc) (nc) IN2 IN4 IN- IN- FG FG for 3-wire sensors Functional ground (FG) Ground connection via mounting base PWR/ FAULT PWR/ FAULT 1 1 2 2 ADDR U® LISTED 57M3 IND. CONT. EQ. CLASS 2 CIRCUIT ONLY Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005
Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005 AS-Interface sensor module Technical data General specifications Slave type Double A/B slave Indicators/operating means LED PWR/FAULT 2 dual LED green/red green:AS-Interface voltage red: communication error or address 0 green/red flashing: overload sensor supply LED IN switching state(input); 8 LED yellow Electrical specifications Protection class III Rated operational voltage Ue 26.5 ... 31.6 V from AS-Interface Rated operational current Ie ≤ 80 mA (without sensors) / max. 280 mA Input Number/Type 2x 4 inputs for 2- or 3-wire sensors (PNP), DC alternative 2x 2 inputs for 4-wire sensors (PNP), DC Supply from AS-Interface Voltage 21 ... 31 V Current loading capacity ≤ 200 mA, overload and short-circuit protected Input current ≤ 8 mA (limited internally) Switching point according to DIN EN 61131-2 (Type 2) 0 (unattenuated) ≤ 2 mA 1 (attenuated) ≥ 4 mA Programming instructions Profile S-0.A.2 IO code 0 ID code A ID1 code 7 ID2 code 2 Data bits (function via AS-Interface) Input slave 1 input slave 2 D0 IN1.1 IN2.1 D1 IN1.2 IN2.2 D2 IN1.3 IN2.3 D3 IN1.4 IN2.4 Parameter bits (programmable via AS-i) function P0 not used P1 not used P2 not used P3 Ambient conditions not used Ambient temperature -25 ... 60 °C (248 ... 333 K) Storage temperature Mechanical specifications -25 ... 85 °C (248 ... 358 K) Protection degree IP67 according to EN 60529 Connection cable piercing method flat cable yellow inputs: M12 round connector Mass 135 g Mounting Mounting base Notes With 4-wire sensors, only plug-in slots IN1.1, IN1.3, IN2.1 or IN2.3 can be used from inputs IN1.1+IN1.2, IN1.3+IN1.4, IN2.1+IN2.2 or IN2.3+IN2.4 (jumpered internally). Function VBA-8E-G2-ZA The VBA-8E-G2-ZA is an AS-Interface I/O module with 8 inputs. Both 2-wire and 3-wire sensors can be connected to the inputs as well as 4-wire sensors and mechanical contacts (for example a pushbutton switch). The IP67 flat module is ideally suited for use in the field. The module uses two addresses and behaves externally like two separate 4E modules. Inputs 1.1 ... 1.4 are assigned to Slave 1, while inputs 2.1 ... 2.4 are assigned to Slave 2. A double addressing socket is integrated into the module for separate addressing of the two slaves. The slaves must be addressed before the unit is placed in service. The connection to the sensors is set up by means of M12 x 1-screw connections. An LED is available for each channel to display the current switching status. It is located on the top side of the module. An LED is also available for each of the slaves for monitoring AS-Interface communication and for displaying that a slave has 0 as an address. An overload on the sensor power supply is shown by both LEDs. By default, the U-G2FF mounting plate is used to connect to the AS-Interface flat cable. This lower section allows for contact with the flat cable from both sides. If input and output modules are used in a single system, the flat cable can also be inserted into the lower section for external power supply. The module will not access this line. The advantage this offers is that both flat cables can be laid essentially in parallel without introducing the danger that an incorrect connection would destroy the module. Note: The mounting plate for the module must be ordered separately. Accessories VBP-HH1 Hand-held programming device VAZ-PK-1,5M-V1-G Connection cable module/hand-held programming device VAZ-FK-ED-G2 AS-Interface end seal for G2 modules VAZ-V1-B1 Blanking plug for M12 addressing socket Matching system components U-G2FF Mounting plate for connection to flat cable (AS-Interface and external auxiliary power) Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com 157 Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories
Page 1 and 2:
FACTORY AUTOMATION Sensor systems 2
Page 3 and 4:
Issue date 2004-11-19 - Catalogue A
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102: Issue date 2004-11-19 - Catalogue A
Page 151: Issue date 2004-11-19 - Catalogue A
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
VAZ-PB-SIM Issue date 2004-11-19 -
Page 309 and 310:
VAZ-R4-R2 Issue date 2004-11-19 - C
Page 311 and 312:
U-G1FA Issue date 2004-11-19 - Cata
Page 313 and 314:
U-G1FFA Issue date 2004-11-19 - Cat
Page 315 and 316:
U-G1PP Issue date 2004-11-19 - Cata
Page 317 and 318:
U-G3FF Issue date 2004-11-19 - Cata
Page 319 and 320:
VAZ-T1-FK-1M-PUR-V1-W Issue date 20
Page 321 and 322:
VAZ-T1-G2F Issue date 2004-11-19 -
Page 323 and 324:
VAZ-T1-FK-M20 Issue date 2004-11-19
Page 325 and 326:
VAZ-V1-B Issue date 2004-11-19 - Ca
Page 327 and 328:
VAZ-TERM Issue date 2004-11-19 - Ca
Page 329 and 330:
Page 331 and 332:
UPR-05 Issue date 2004-11-19 - Cata
Page 333 and 334:
Page 335 and 336:
Page 337 and 338:
Page 339 and 340:
Page 341 and 342:
Page 343 and 344:
Page 345 and 346:
Page 347 and 348:
Page 349 and 350:
Date of issue 2004-19-11 - Catalogu
Page 351 and 352:
Page 353 and 354:
Page 355 and 356:
show all

Sensor systems 2 AS-Interface

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?