Sensor systems 2 AS-Interface

Recommendations

Info

VBA-4E2A-KE1-Z/E2 Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories AS-Interface sensor-/actuator module Features A/B slave with extended addressing possibility for up to 62 slaves Housing with removable terminals Communication monitoring Inputs for 2-wire sensors and mechanical contacts Addressing jack Power supply of outputs from the external auxiliary voltage Power supply of inputs from the module Function display for bus, ext. auxiliary voltage, inputs and outputs 142 U® Order code VBA-4E2A-KE1-Z/E2 KE1 switch cabinet module 4 inputs and 2 outputs 62 Spec 2.1 Dimensions Electrical connection AS-Interface - AS-Interface + ADDR AUX + AUX - PWR FAULT AUX Indicating/operating means VBA-4E2A-KE1-Z/E2 Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com 22.5 IN1 IN2 IN3 IN4 I+ 1 I+ 2 I+ 3 I+ 4 1 2 IN FAULT PWR ADDR 1 2 OUT 3 4 AUX 01 0 1 02 0 2 AS-i+ AS-i AUX+ AUX 50.5 48.5 IN OUT 99.6 4 inputs IN1 ... IN4 I+ IN 2 outputs O1, O2 O O- Load Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005
Issue date 2004-11-19 - Catalogue AS-Interface 2004/2005 AS-Interface sensor-/actuator module Technical data General specifications Slave type Indicators/operating means A/B slave LED FAULT error display; LED red red: communication error or address is 0 red flashing: overload of outputs LED PWR AS-Interface voltage; LED green LED AUX ext. auxiliary voltage UAUX; LED green LED IN switching state (input); 4 LED yellow LED OUT Electrical specifications switching state (output); 2 LED yellow Auxiliary voltage (output) UAUX 20 ... 30 V DC PELV Protection class III Rated operational voltage Ue 26.5 ... 31.6 V from AS-Interface Rated operational current Ie ≤ 25 mA (without sensors) / max. 60 mA Overvoltage protection Input UAUX, Ue: Over voltage category III, safe isolated power supplies (PELV) Number/Type 4 inputs for 2-wire sensors (PNP), DC or for mechanical contacts Input current ≤ 8 mA (limited internally) Switching point according to DIN EN 61131-2 (Type 2) 0 (unattenuated) ≤ 2 mA 1 (attenuated) ≥ 4 mA Signal delay < 2 ms (input/AS-Interface) Signal frequency ≤ 250 Hz Output Number/Type 2 electronic outputs, PNP, overload and short-circuit proof Supply from external auxiliary voltage U AUX Current O1/O2 max. 1.5 A, total 3 A (T B ≤ 40 °C) O1/O2 max. 1 A, total 2 A (T B ≤ 70 °C) Voltage ≥ (U AUX - 0,5 V) Usage category DC-13 Programming instructions Profile S-7.A.0 IO code 7 ID code A ID1 code 7 ID2 code 0 Data bits (function via AS-Interface) input output D0 IN1 O1 D1 IN2 O2 D2 IN3 - D3 IN4 - Parameter bits (programmable via AS-i) function P0 not used P1 not used P2 not used P3 Ambient conditions not used Ambient temperature -25 ... 70 °C (248 ... 343 K) Storage temperature -25 ... 85 °C (248 ... 358 K) Relative humidity 90 % , not condensed Degree of soiling Mechanical specifications 2 Protection degree IP20 according to EN 60529 Connection removable terminals rated connection capacity: rigid/flexible (with and without wire-end ferrules): 0.25 mm2 ... 2.5 mm2 for multiple-wire connection with two wires of equal cross-section: flexible with twin wire-end ferrules: 0.5 mm2 ... 1.5 mm2 Mass 80 g Mounting DIN rail Function VBA-4E2A-KE1-Z/E2 The VBA-4E2A-KE1-Z/E2 AS-interface coupling module is a cabinet module with 4 inputs and 2 electronic outputs. The housing, only 22.5 mm in width and 48.5 mm in height, takes up little place in the switch cabinet. The module is mounted by snapping onto the 35 mm DIN rail in accordance with EN 50022. Plug-in terminals are used for connection. 4way terminal blocks (black) are used for the inputs. The connection of the outputs and the external auxiliary supply and AS-Interface is made through the 2-way terminal blocks (outputs black, auxiliary voltage gray and AS- Interface yellow). This makes it possible to separate individual actuators or to supply power during commissioning or servicing. The supply of the inputs and the connected sensors occurs internally via the module (from AS-Interface). An LED on the front control plate is used to display the current switching state for each input and output. Note: The device is equipped with a watchdog, which switches the outputs to their de-energized state, when on the AS-interface cable is no communication for more than 40 ms. An overload of the outputs is reported by the 'periphery error' to the AS-Interface master. Communication over the AS-Interface remains in effect. Accessories VBP-HH1 Hand-held programming device VAZ-PK-1,5M-V1-G Connection cable module/hand-held programming device Subject to reasonable modifications due to technical advances. Copyright Pepperl+Fuchs, Printed in Germany Pepperl+Fuchs Group Tel.: Germany +49 621 776-0 USA +1 330 4253555 Singapore +65 67799091 Internet http://www.pepperl-fuchs.com 143 Masters and Gateways Power Supplies, Extender, Repeaters Safety at work I/O Modules Control cabinet I/O Modules Field application Analogue modules Other modules Inductive sensors Photoelectric sensors Rotary encoders Accessories
Page 1 and 2:
FACTORY AUTOMATION Sensor systems 2
Page 3 and 4:
Issue date 2004-11-19 - Catalogue A
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88: Issue date 2004-11-19 - Catalogue A
Page 137: Issue date 2004-11-19 - Catalogue A
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Page 295 and 296:
Page 297 and 298:
Page 299 and 300:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 307 and 308:
VAZ-PB-SIM Issue date 2004-11-19 -
Page 309 and 310:
VAZ-R4-R2 Issue date 2004-11-19 - C
Page 311 and 312:
U-G1FA Issue date 2004-11-19 - Cata
Page 313 and 314:
U-G1FFA Issue date 2004-11-19 - Cat
Page 315 and 316:
U-G1PP Issue date 2004-11-19 - Cata
Page 317 and 318:
U-G3FF Issue date 2004-11-19 - Cata
Page 319 and 320:
VAZ-T1-FK-1M-PUR-V1-W Issue date 20
Page 321 and 322:
VAZ-T1-G2F Issue date 2004-11-19 -
Page 323 and 324:
VAZ-T1-FK-M20 Issue date 2004-11-19
Page 325 and 326:
VAZ-V1-B Issue date 2004-11-19 - Ca
Page 327 and 328:
VAZ-TERM Issue date 2004-11-19 - Ca
Page 329 and 330:
Page 331 and 332:
UPR-05 Issue date 2004-11-19 - Cata
Page 333 and 334:
Page 335 and 336:
Page 337 and 338:
Page 339 and 340:
Page 341 and 342:
Page 343 and 344:
Page 345 and 346:
Page 347 and 348:
Page 349 and 350:
Date of issue 2004-19-11 - Catalogu
Page 351 and 352:
Page 353 and 354:
Page 355 and 356:
show all

Sensor systems 2 AS-Interface

Create successful ePaper yourself

Delete template?

Save as template?