You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2 INSTALLATION<br />
2.2 Installing the Antenna Units<br />
2.2.1 Antenna unit SC-303<br />
2-4<br />
Note: “Bird-repellent fixtures” may be attached to the antenna cover to prevent<br />
birds from alighting on the cover. If it is more convenient to attach them<br />
before fixing the antenna unit to the mounting location, do step 9 before<br />
fixing the antenna unit.<br />
NOTICE<br />
Fasten the antenna to the mounting<br />
location lastly if it is more convenient<br />
to connect the antenna cable before<br />
mounting the antenna unit.<br />
1. Prepare a mounting platform (wood, steel or aluminum) in accordance with<br />
the illustration shown below. If corrosive material is used, take necessary<br />
anti-corrosion measures.<br />
Note: When drilling holes in the platform, be sure they are parallel with the<br />
fore-and-aft line.<br />
2. Fasten the antenna unit to the platform with four sets of M10 hex. bolts,<br />
spring washers and flat washers, orienting it as shown below. (The bow mark<br />
(�) on the antenna should face the bow.) The torque for the hex. bolts<br />
should be between 19.6-24.5 Nm.<br />
NOTICE<br />
Do not open the antenna.<br />
This installation does not require removal<br />
of the antenna cover.<br />
240<br />
160<br />
240<br />
160<br />
F<br />
R<br />
U<br />
U<br />
Mounting dimensions for antenna, orienting the antenna<br />
N<br />
BOW<br />
Fixing Hole<br />
(�11 mm)<br />
Flat Washer<br />
Spring Washer<br />
Hex. Bolt