(Yield) Maps - StellarSupport - John Deere

81
Setup
Contractor tab. This will need to be done prior to entering the contract information.
7. In Trait description, enter necessary parameters of why the contract was negotiated.
8. In Quantity, enter the number of units that were negotiated in the contract.
9. In Units, select the unit of measure that corresponds to the quantity.
10. In Fields, click Make selections.
11. Place a check next to the name of the farm that is
included in the contract.
12. On the right, check each field for the selected farm that
is included in the contract.
13. Click OK.
14. When finished, click Apply to save your changes and
move to the next tab, or click OK to close the Setup tabs.
Contractor Setup
The company that issues the contract is called the Contractor. The Contractor tab allows
you to record the company’s contact information. Do not add new contractors by typing
over old ones, as each contractor will need a separate tag number and these are only
assigned when New is selected.
The Contractor tab is directly linked to the Contract tab. However, the contractors must be
entered prior to adding the contracts, as the data on this screen is used to populate the
Contract tab.
To make a contractor inactive (or active) refer to page 46.
Add a contractor:
1. From the Setup menu, select Contracts.
2. Select the Contractor tab.