(Yield) Maps - StellarSupport - John Deere

JDOffice 1.2
6. In Carrier, select the liquid that will be used to dilute the mix.
• If the carrier you need is not in the list, you will need to add it to the Carrier Setup
tab first, then return to this tab to select it.
7. Enter the Cost per acre to use the tank mix.
8. Click Tank Blend to define the components (and their rates) that are found in the mix.
9. When finished, click Apply to save your changes and move to the next tab, or click
OK to close the Setup tabs.
Locked Tank Mixes
Once a tank mix is assigned to a task - either through the Builder or the Wizard - it will
become locked on the Setup screen to protect the components and ratios that were used
in the field (legacy data). The solution rate, nor the components of the mix can be altered
once it is locked. However, locked tank mixes can continue to be used in additional tasks.
Tank Mix Blend
After entering a solution on the Tank Mix tab, click the Tank Blend button to define the
individual components of that mix (first verify that the mix is highlighted in the Tank mix
list).
Each row on the Tank Blend screen contains all the information for each pesticide or
herbicide in the tank mix. There is a maximum of 6 components - additional rows cannot
be added.
Enter the Components of a Tank Mix:
In each cell (except Rate) you must click on the drop-down arrow to display the list of
choices for that cell.
1. In the Category column, select Fertilizer or Pesticide.
62