(Yield) Maps - StellarSupport - John Deere

Products
53
Setup
Any crops or chemicals that are put into your fields are defined as products. The Products
Setup section breaks down these inputs into six tabs: Crop, Variety, Fertilizer, Pesticide,
Tank Mix, and Carrier. There are master lists on each tab and new inputs can continually
be added.
If an item has been used in the Task Builder or the Task Wizard as part of an operation,
or if it had been previously used in unloaded data, you will not be able to inactivate it.
Crop Setup
All of the crops that JDOffice supports are listed alphabetically on this tab - crops cannot
be added or deleted. The Crop tab is independent of the year, farm or field; however, it is
directly linked to the Variety tab.
The Standard payable moisture percentage (moisture level at which the elevator will
pay) and Crop weight (standard dry measure) are provided for each. These two values
are used to calculate the average dry yields and total dry yields. These calculations shrink
the measured yield to a dry yield by reducing the moisture from the actual level recorded
by the sensors in the combine to the standard payable moisture at the grain elevator.
Yield is calculated by the GreenStar Display; therefore any changes to these values need
to be saved to the PC Card prior to going to the field. If your local elevator uses different
values, update these numbers prior to unloading your data.
JDOffice lists crops that are dominant in three different continents. Depending on your
locale, some crops will be inactive when JDOffice is shipped. To make a crop inactive (or
active) refer to page 46. For a complete list of the crops that JDOffice supports, refer to
page 309 in the Appendix.
Edit the crop values:
1. From the Setup menu, select Products.