(Yield) Maps - StellarSupport - John Deere

39
Preferences
sites around the perimeter and in the areas that you were not harvesting, but didn’t raise
your header.
1. In Start and End of pass delay, enter a zero (0).
2. Check Include area for points that have zero grain flow.
II. Visually appealing maps. Use if your primary concern is clean maps and not the
preciseness of the number of acres matching the combine.
1. In Start and End of pass delay, enter a value (0-4 seconds).
2. Uncheck Include area for points that have zero grain flow.
III. Accurate acreage correlation AND visually appealing maps. Use if you want both
visually pleasing maps and accurate acreage correlation at the same time. The low yield
points will be moved to the “bottom” of the map.
1. In Start and End of pass delay, enter a zero (0).
2. Check Include area for points that have zero grain flow.
3. On the Maps Preferences tab, check Draw points in reverse on Field Map.
Show files in Unload Chooser exclusively for current client
This option protects you from unloading the wrong data from one client’s PC Card into
another’s farm. An error message will let you know that no data files for the current client
were found.
It works on a single client system by verifying the disk, and on a multi-client system by
verifying the client number. If this is unchecked, all files on the PC Card will be visible (and
able to unload) in the Unload PC Card window.
Warn if distance between target farm and field exceeds n miles
Farms are defined by the fields within them. If you are unloading a field into a farm that is
more than n (“n” is the number you designate) miles from that farm’s nearest field,
JDOffice will give you a proximity warning. This warning alerts you to the fact that this field
may not belong to the selected farm. You can click OK and continue if you are sure it
belongs, or you can click OK and select another farm.
Note: 25 miles is the default distance.